Subsynchronous Impedance Measurement of a Megawatt-Level Grid-Tied Inverter Using Controller Hardware-in-the-Loop
Authors:
- 24 May 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1009-1014
Abstract
The penetration of renewable energy sources into the power grid has increased considerably during the past few decades. Modern power systems may include a variety of power sources such as photovoltaic (PV), wind turbines, energy storage systems, in addition to the conventional power plants. Such systems require careful stability analysis to prevent stability issues that may cause damage. One important case is the subsynchronous resonance that appears due to the interaction between inverters and series compensated power lines, which has caused damage and power failure recently. Impedance stability analysis is a powerful tool that is used for this purpose. In this model, a power source is represented as current source in parallel with a Norton impedance. However, measurement of the equivalent impedance model can be a difficult task in practice, particularly for high capacity inverters. In this paper, controller hardware-in-the-loop (C-HIL) is used to measure the subsynchronous impedance of a 3.36 MW PV inverter. The results show that measurement with C-HIL provides a powerful and accurate solution for this purpose that precludes the need for full hardware testing. A simulation model using PSCAD software is also built and the impedance measurement results are compared with the experiment.Keywords
This publication has 18 references indexed in Scilit:
- Sequence Domain SISO Equivalent Models of a Grid-Tied Voltage Source Converter System for Small-Signal Stability AnalysisIEEE Transactions on Energy Conversion, 2017
- A Modified Sequence-Domain Impedance Definition and Its Equivalence to the dq-Domain Impedance Definition for the Stability Analysis of AC Power Electronic SystemsIEEE Journal of Emerging and Selected Topics in Power Electronics, 2016
- Sequence impedance measurement of three-phase inverters using a parallel structure2015
- Analysis of D-Q Small-Signal Impedance of Grid-Tied InvertersIEEE Transactions on Power Electronics, 2015
- Investigation of SSR in Practical DFIG-Based Wind Farms Connected to a Series-Compensated Power SystemIEEE Transactions on Power Systems, 2014
- Impedance Shaping of the Grid-Connected Inverter with LCL Filter to Improve Its Adaptability to the Weak Grid ConditionIEEE Transactions on Power Electronics, 2014
- Stationary Frame Equivalent Model of Proportional-Integral Controller in dq Synchronous FrameIEEE Transactions on Power Electronics, 2014
- Three-phase AC system impedance measurement unit (IMU) using chirp signal injection2013
- Ercot experience screening for Sub-Synchronous Control Interaction in the vicinity of series capacitor banks2012
- Input-Admittance Calculation and Shaping for Controlled Voltage-Source ConvertersIEEE Transactions on Industrial Electronics, 2007