Optimization of Josephson Junction Comparators in Terms of Speed and Accuracy
Authors:
- 29 November 2010
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 21 (3) , 687-692
Abstract
This paper investigates the trade-off between speed and accuracy of a Josephson comparator by numerical simulations. The accuracy is quantified by the width of the gray zone whereas the speed is determined by the switching time of the comparator cell. In contrast to previous studies, both performance parameters are simultaneously evaluated. It turns out that there is an inherent compromise between speed and accuracy that is robust against modifications of circuit parameters. Eventually, a new comparator topology is proposed to improve the accuracy while maintaining a reasonable switching speed.Keywords
This publication has 9 references indexed in Scilit:
- Experimentally verified design guidelines for minimizing the gray zone width of Josephson comparatorsSuperconductor Science and Technology, 2010
- Quantitative evaluation of delay time in the single-flux-quantum circuitPhysica C: Superconductivity and its Applications, 2007
- Noise analysis for intrinsic and external shunted Josephson junctionsSuperconductor Science and Technology, 2004
- Performance assessment of multiobjective optimizers: an analysis and reviewIEEE Transactions on Evolutionary Computation, 2003
- RSFQ TECHNOLOGY: PHYSICS AND DEVICESInternational Journal of High Speed Electronics and Systems, 2001
- Time characteristics of a Josephson-balanced comparatorSuperconductor Science and Technology, 1999
- SFQ balanced comparators at a finite sampling rateIEEE Transactions on Applied Superconductivity, 1997
- Stochastic simulation of SFQ logicIEEE Transactions on Applied Superconductivity, 1997
- Signal resolution of RSFQ comparatorsIEEE Transactions on Applied Superconductivity, 1995