The investigation of the electrocatalytic and corrosion behavior of a TiO2–RuO2 anode modified by graphene oxide and reduced graphene oxide nanosheets via a sol–gel method
- 4 September 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 8 (19) , 4957-4974
Abstract
A unique electrocatalyst composed of a dimensionally stable anode (DSA) of graphene oxide and reduced graphene oxide combined with RuO2 and TiO2 nanoparticles has been synthesized on a titanium substrate through a facile aqueous sol–gel method. The surface morphology, microstructure and composition of the coatings were investigated by field emission scanning electron microscopy (FE-SEM), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD) analysis, Fourier transform infrared spectroscopy (FT-IR) and inductively coupled plasma optical emission spectroscopy (ICP-OES). The contribution of the graphene compounds into the anode composition to improve the corrosion and electrocatalytic features was investigated by cyclic voltammetry (CV), polarization measurements, electrochemical impedance spectroscopy (EIS) and an accelerated stability test (AST). The most efficient anode passed the maximum electrical charge at about 145.2 mC cm−2, which was 4.5 times higher than the RuO2–TiO2 (RT) coating, in 0.5 M NaCl + 1 M H2SO4 solution and it was found that the specific current density per unit of the actual surface area (is) ratio of chlorine and oxygen evolution for the optimized electrode was about 3 times higher than the RT electrode which indicates the considerable selectivity behavior of this electrode. The charge transfer resistance of the novel DSA reduced to 2.39 kΩ, while the stability and coating lifetime was improved to 7530 h at j = 1.2 A cm−2 which illustrates that graphene oxide can be used to improve the electrocatalytic performance of DSA anodes.Keywords
Funding Information
- Iran National Science Foundation
This publication has 92 references indexed in Scilit:
- Utilization of the catalyst layer of dimensionally stable anodes—Interplay of morphology and active surface areaElectrochimica Acta, 2012
- Microstructural impact of anodic coatings on the electrochemical chlorine evolution reactionPhysical Chemistry Chemical Physics, 2012
- Graphene-based materials for catalysisCatalysis Science & Technology, 2011
- Fabrication of a titanium anode with an active coating based on mixed oxides of base metalsRussian Journal of Applied Chemistry, 2010
- Deactivation mechanisms of oxygen evolving anodes at high current densitiesElectrochimica Acta, 1994
- “Inner” and “outer” active surface of RuO2 electrodesElectrochimica Acta, 1990
- Electrocatalysis in the anodic evolution of oxygen and chlorineElectrochimica Acta, 1984
- Some oxide catalysts for the anodic evolution of chlorine: reaction mechanism and catalytic activityElectrochimica Acta, 1978
- Studies on the Oxide‐Coated Metal Anodes for Chlor‐Alkali CellsJournal of the Electrochemical Society, 1977
- Preparation of Graphitic OxideJournal of the American Chemical Society, 1958