Effect of Metal Foam Insert Configurations on Flow Boiling Heat Transfer and Pressure Drop in a Rectangular Channel
Open Access
Abstract
Heat transfer under flow boiling is better in a rectangular channel filled with open-cell metal foam than in an empty channel, but the high pressure drop is a drawback of the empty channel method. In this study, various types of metal foam insert configurations were tested to reduce the pressure drop while maintaining high heat transfer. Specifically, we measured the boiling heat transfer and pressure drop of a two-phase vertical upward flow of R245fa inside a channel. To measure the pressure and temperature differences of the metal foam, differential pressure transducers and T-type thermocouples were used at both ends of the test section. While the saturation pressure was kept constant at 5.9 bar, the steam quality at the inlet of the test section was changed from 0.05 to 0.99. The channel height, moreover, was 3 mm, and the mass flux ranged from 133 to 300 kg/m2s. The two-phase flow characteristics were observed through a high-speed visualization experiment. Heat transfer tended to increase with the mean vapor quality, and, as expected, the fully filled metal foam channel offered the highest thermal performance. The streamwise insert pattern model had the lowest heat transfer at a low mass flux. However, at a higher mass flux, the three different insert models presented almost the same heat transfer coefficients. We found that the streamwise pattern model had a very low pressure drop compared to that of the spanwise pattern models. The goodness factors of the flow area and the core volume of the streamwise patterned model were higher than those of the full-filled metal foam channel.Keywords
Funding Information
- National Research Foundation of Korea (No. 2020R1A5A8018822)
This publication has 35 references indexed in Scilit:
- Experimental and numerical study of single and two-phase flow and heat transfer in aluminum foamsInternational Journal of Heat and Mass Transfer, 2011
- Experimental investigation of single phase convective heat transfer coefficient in a corrugated plate heat exchanger for multiple plate configurationsApplied Thermal Engineering, 2010
- Numerical Modelling of Flow Boiling Heat Transfer in Horizontal Metal‐Foam TubesAdvanced Engineering Materials, 2009
- Experimental Analysis of Multiphase Flow in Metallic foam: Flow Laws, Heat Transfer and Convective BoilingAdvanced Engineering Materials, 2006
- Investigation of flow boiling in horizontal tubes: Part I—A new diabatic two-phase flow pattern mapInternational Journal of Heat and Mass Transfer, 2005
- Metal foams as compact high performance heat exchangersMechanics of Materials, 2003
- Experiments on the characteristics of evaporation of R410A in brazed plate heat exchangers with different geometric configurationsApplied Thermal Engineering, 2003
- Saturated flow boiling heat transfer and pressure drop of refrigerant R-410A in a vertical plate heat exchangerInternational Journal of Heat and Mass Transfer, 2002
- Forced convection from aluminum foam materials in an asymmetrically heated channelInternational Journal of Heat and Mass Transfer, 2001
- A flow pattern map for gas—liquid flow in horizontal pipesInternational Journal of Multiphase Flow, 1974