Stress‐controlled weakly periodic boundary conditions: Axial stress under varying orientations
Open Access
- 2 June 2020
- journal article
- research article
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 121 (19) , 4458-4470
Abstract
Summary: The accuracy of multiscale modeling approaches for the analysis of heterogeneous materials hinges on the representativeness of the micromodel. One of the issues that affects this representativeness is the application of appropriate boundary conditions. Periodic boundary conditions are the most common choice. However, when localization takes place, periodic boundary conditions tend to overconstrain the microscopic problem. Weakly periodic boundary conditions have been proposed to overcome this effect. In this study, the effectiveness of weakly periodic boundary conditions in restoring transverse isotropy of representative volume elements (RVE) for a fiber‐reinforced composite with elastoplastic matrix is investigated. The formulation of weakly periodic boundary conditions is extended to allow for force‐controlled simulations where a uniaxial stress can be applied. A series of simulations is performed where the orientation of applied stress is gradually varied and the influence of this orientation on the averaged response is examined. An original method is presented to test the correlation between the ultimate principal stress and average localization angle of shear bands within an RVE. It is concluded that weakly periodic boundary conditions alleviate anisotropy in the RVE response but do not remove it.Keywords
This publication has 8 references indexed in Scilit:
- A combined experimental/numerical investigation on hygrothermal aging of fiber-reinforced compositesEuropean Journal of Mechanics - A/Solids, 2019
- Localization aligned weakly periodic boundary conditionsInternational Journal for Numerical Methods in Engineering, 2017
- Micromechanical validation of a mesomodel for plasticity in compositesEuropean Journal of Mechanics - A/Solids, 2016
- On the variationally consistent computational homogenization of elasticity in the incompressible limitAdvanced Modeling and Simulation in Engineering Sciences, 2015
- Micromechanical analysis of polymer composites reinforced by unidirectional fibres: Part II – Micromechanical analysesInternational Journal of Solids and Structures, 2013
- Novel boundary conditions for strain localization analyses in microstructural volume elementsInternational Journal for Numerical Methods in Engineering, 2011
- Computational homogenization based on a weak format of micro-periodicity for RVE-problemsComputer Methods in Applied Mechanics and Engineering, 2011
- Multi-scale computational homogenization: Trends and challengesJournal of Computational and Applied Mathematics, 2010