Effect of cutting speed on chip formation and wear mechanisms of coated carbide tools when ultra-high-speed face milling titanium alloy Ti-6Al-4V
Open Access
- 21 July 2017
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 9 (7)
Abstract
Chip morphology and its formation mechanisms, cutting force, cutting power, specific cutting energy, tool wear, and tool wear mechanisms at different cutting speeds of 100–3000 m/min during dry face milling of Ti-6Al-4V alloy using physical vapor deposition-(Ti,Al)N-TiN-coated cemented carbide tools were investigated. The cutting speed was linked to the chip formation process and tool failure mechanisms of the coated cemented cutting tools. Results revealed that the machined chips exhibited clear saw-tooth profile and were almost segmented at high cutting speeds, and apparent degree of saw-tooth chip morphology occurred as cutting speed increased. Abrasion in the flank face, the adhered chips on the wear surface, and even melt chips were the most typical wear forms. Complex and synergistic interactions among abrasive wear, coating delamination, adhesive wear, oxidation wear, and thermal mechanical–mechanical impacts were the main wear or failure mechanisms. As the cutting speed was very high (>2000 m/min), discontinuous or fragment chips and even melt chips were produced, but few chips can be collected because the chips easily burned under the extremely high cutting temperature. Large area flaking, extreme abrasion, and serious adhesion dominated the wear patterns, and the tool wear mechanisms were the interaction of thermal wear and mechanical wear or failure under the ultra-high frequency and strong impact thermo-mechanical loads.Keywords
This publication has 26 references indexed in Scilit:
- Performance and wear analysis of polycrystalline diamond (PCD) tools manufactured with different methods in turning titanium alloy Ti-6Al-4VThe International Journal of Advanced Manufacturing Technology, 2015
- Experimental evaluation of polycrystalline diamond (PCD) tool geometries at high feed rate in milling of titanium alloy TC11The International Journal of Advanced Manufacturing Technology, 2014
- Thermal characteristics in milling Ti6Al4V with polycrystalline diamond toolsThe International Journal of Advanced Manufacturing Technology, 2014
- Influence of cutting speed on cutting force, flank temperature, and tool wear in end milling of Ti-6Al-4V alloyThe International Journal of Advanced Manufacturing Technology, 2013
- Evolution of tool wear and its effect on cutting forces during dry machining of Ti-6Al-4V alloyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2013
- Tool life and wear mechanisms in high speed machining of Ti–6Al–4V alloy with PCD tools under various coolant pressuresJournal of Materials Processing Technology, 2013
- Failure mode analysis of carbide cutting tools used for machining titanium alloyCeramics International, 2013
- An experimental and numerical study on the face milling of Ti–6Al–4V alloy: Tool performance and surface integrityJournal of Materials Processing Technology, 2011
- Wear characteristics and performance of multi-layer CVD-coated alloyed carbide tool in dry end milling of titanium alloySurface and Coatings Technology, 2006
- Evaluation of wear mechanisms of coated carbide tools when face milling titanium alloyJournal of Materials Processing Technology, 2000