Removing Grit During Wastewater Treatment:CFD Analysis of HDVS Performance
Authors:
- Robert E. ShekerRSRobert E. Sheker
- 1 May 2016
- journal article
- Published by Wiley in Water Environment Research
- Vol. 88 (5) , 438-448
Abstract
: Computational Fluid Dynamics (CFD) was used to simulate the grit and sand separation effectiveness of a typical hydrodynamic vortex separator (HDVS) system. The analysis examined the influences on the separator efficiency of: flow rate, fluid viscosities, total suspended solids (TSS), and particle size and distribution. It was found that separator efficiency for a wide range of these independent variables could be consolidated into a few curves based on the particle fall velocity to separator inflow velocity ratio, Ws/Vin. Based on CFD analysis it was also determined that systems of different sizes with length scale ratios ranging from 1 to 10 performed similarly when Ws/Vin and TSS were held constant. The CFD results have also been compared to a limited range of experimental data.Keywords
This publication has 19 references indexed in Scilit:
- Large eddy simulation of mechanical mixing in anaerobic digestersBiotechnology and Bioengineering, 2011
- CFD investigation of turbulence models for mechanical agitation of non-Newtonian fluids in anaerobic digestersWater Research, 2011
- CFD simulation of gas and non-Newtonian fluid two-phase flow in anaerobic digestersWater Research, 2010
- Rheological Characterization of Sludge Coming from a Wastewater Treatment PlantAmerican Journal of Environmental Sciences, 2010
- CFD simulation of mechanical draft tube mixing in anaerobic digester tanksWater Research, 2009
- CFD simulation of non‐Newtonian fluid flow in anaerobic digestersBiotechnology and Bioengineering, 2007
- Rheological measurements of sewage sludge for various solids concentrations and geometryProcess Biochemistry, 2006
- Removal efficiency of swirl/vortex separatorsUrban Water Journal, 2004
- Efficiency prediction for storage chambers using computational fluid dynamicsWater Science & Technology, 1996
- Perspective: A Method for Uniform Reporting of Grid Refinement StudiesJournal of Fluids Engineering, 1994