Assessment of the Effect of Low Cetane Number Fuels on a Light Duty CI Engine: Preliminary Experimental Characterization in PCCI Operating Condition
- 11 September 2011
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The goal of this paper is to acquire insight into the influence of cetane number (CN) and fuel oxygen on overall engine performance in the Premixed Charge Compression Ignition (PCCI) combustion mode.From literature, it is known that low reactive (i.e., low CN) fuels increase the ignition delay (ID) and therefore the degree of mixing prior to auto-ignition. With respect to fuel oxygen, it is known that this has a favorable impact on soot emissions by means of carbon sequestration. This makes the use of low CN oxygen fuels an interesting route to improve the applicability of PCCI combustion in diesel engines. In earlier studies, performed on a heavy-duty engine, cyclic oxygenates were found to consistently outperform their straight and branched counterparts with respect to curbing soot. This was attributed to a considerably lower CN.The oxygenate in question, cyclohexanone (C₆H₁₀O), has the advantage of being producible in a renewable way from lignin, a second generation biomass waste stream (e.g., paper pulp industry). To investigate the impact of cyclohexanone on diesel combustion and pollutant emissions in greater detail, a parametric test program was carried out in a joint project between Istituto Motori (Naples) and the University of Technology Eindhoven.To decouple the influence of a low cetane number and fuel oxygen content on the engine performance, diesel (commercial high quality diesel fuel), gasoline (commercial high quality gasoline) and cyclohexanone were blended into five mixtures, with varying cetane number or oxygen content. These blends were tested and compared on a modern single-cylinder light-duty (LD) direct injection (DI) research diesel engine. The results suggest that it is not possible to attribute favorable performance to either CN or fuel oxygen, but rather to the combination of both properties. In nearly all investigated work points, a decrease in CN led to a decrease in nitric oxides (NOx) and particulate matter (PM), whilst slightly increasing carbon monoxide (CO) and unburned hydrocarbons (UHC). At an equal CN, the results suggest that fuel oxygen reduces soot emissions and also plays a role in suppressing UHC and CO emissions.Keywords
This publication has 12 references indexed in Scilit:
- Flame lift-off length and soot production of oxygenated fuels in relation with ignition delay in a DI heavy-duty diesel engineCombustion and Flame, 2011
- Impact of fuel characteristics on HCCI combustion: Performances and emissionsFuel, 2010
- Optimizing Early Injection Strategy for Diesel PCCI CombustionSAE International Journal of Advances and Current Practices in Mobility, 2009
- Advanced compression-ignition engines—understanding the in-cylinder processesProceedings of the Combustion Institute, 2009
- Cyclic Oxygenates: A New Class of Second-Generation Biofuels for Diesel Engines?Energy & Fuels, 2008
- Experimental Analysis of the Operating Parameter Influence on the application of Low Temperature Combustion in the Modern Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 2007
- Partially Pre-Mixed Auto-Ignition of Gasoline to Attain Low Smoke and Low NOx at High Load in a Compression Ignition Engine and Comparison with a Diesel FuelSAE International Journal of Advances and Current Practices in Mobility, 2007
- Auto-ignition quality of Diesel-like fuels in HCCI enginesSAE International Journal of Advances and Current Practices in Mobility, 2005
- Evaluation of a Narrow Spray Cone Angle, Advanced Injection Timing Strategy to Achieve Partially Premixed Compression Ignition Combustion in a Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2005
- Ultra-Clean Combustion Technology Combining a Low-Temperature and Premixed Combustion Concept for Meeting Future Emission StandardsSAE International Journal of Advances and Current Practices in Mobility, 2001