Structural, Microstructural and Electrochemical Characterization of Ni-YSZ Anodes Fabricated from Pechini-Derived Composite Powders
- 1 August 2020
- journal article
- research article
- Published by Sakarya University Journal of Science in Sakarya University Journal of Science
- Vol. 24 (4) , 740-750
Abstract
The most widely used solid oxide fuel cell (SOFC) anodes, nickel-yttria stabilized zirconia (NiO-YSZ) composites, are generally fabricated by co-sintering of NiO and YSZ powders. In this study, to achieve a longer triple phase boundary length, these composites were fabricated from powders synthesized via an ethylene glycol-based Pechini method. Polymeric precursors of NiO and YSZ were prepared separately and then mixed, dried and calcined 600, 700 and 800°C for 4 hours, in air. NiO and YSZ crystals with average sizes of 26 and 7 nm, respectively were achieved upon calcination at 600 °C. With increasing heat treatment temperature, both the crystal and agglomerate sizes increased, which, in turn, an increased the anode polarization resistances. Electrochemical activities comparable to or higher than anode prepared by co-sintering of powder mixtures were achieved in the anodes prepared by sintering of the composite powders.Keywords
Funding Information
- Türkiye Bilimsel ve Teknolojik Araştırma Kurumu (217M031)
This publication has 19 references indexed in Scilit:
- Effect of the anode microstructure on the enhanced performance of solid oxide fuel cellsInternational Journal of Hydrogen Energy, 2012
- Stability of Ni–yttria stabilized zirconia anodes based on Ni-impregnationJournal of Power Sources, 2010
- Synthesis of nano-crystalline (Ni/NiO)–YSZ by microwave-assisted combustion synthesis method: The influence of pH of precursor solutionJournal of Power Sources, 2008
- Combined Deconvolution and CNLS Fitting Approach Applied on the Impedance Response of Technical Ni∕8YSZ Cermet ElectrodesJournal of the Electrochemical Society, 2008
- Fabrication of NiO/YSZ anode material for SOFC via mixed NiO precursorsMaterials Letters, 2007
- Synthesis and Characterization of NiO–YSZ Anode Materials: Precipitation, Calcination, and the Effects on SinteringJournal of the American Ceramic Society, 2005
- A redox-stable efficient anode for solid-oxide fuel cellsNature Materials, 2003
- Synthesis of NiO–ZrO2 powders for solid oxide fuel cellsCeramics International, 2003
- Assessment of Ni/YSZ anodes prepared by combustion synthesisSolid State Ionics, 2002
- Kinetic studies of the reaction at the nickel pattern electrode on YSZ in H2H2O atmospheresSolid State Ionics, 1994