Moss-like Hierarchical Architecture Self-Assembled by Ultrathin Na2Ti3O7 Nanotubes: Synthesis, Electrical Conductivity, and Electrochemical Performance in Sodium-Ion Batteries
Authors:
- Denis P. OpraDODenis P. Opra
- Anton I. NeumoinANAnton I. Neumoin
- Sergey L. SinebryukhovSSSergey L. Sinebryukhov
- Anatoly B. PodgorbunskyAPAnatoly B. Podgorbunsky
- Valery G. KuryavyiVKValery G. Kuryavyi
- Vitaly Yu. MayorovVMVitaly Yu. Mayorov
- Alexander Yu. UstinovAUAlexander Yu. Ustinov
- Sergey V. GnedenkovSGSergey V. Gnedenkov
Open Access
- 2 June 2022
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 12 (11) , 1905
Abstract
Nanocrystalline layer-structured monoclinic Na2Ti3O7 is currently under consideration for usage in solid state electrolyte applications or electrochemical devices, including sodium-ion batteries, fuel cells, and sensors. Herein, a facile one-pot hydrothermal synthetic procedure is developed to prepare self-assembled moss-like hierarchical porous structure constructed by ultrathin Na2Ti3O7 nanotubes with an outer diameter of 6–9 nm, a wall thickness of 2–3 nm, and a length of several hundred nanometers. The phase and chemical transformations, optoelectronic, conductive, and electrochemical properties of as-prepared hierarchically-organized Na2Ti3O7 nanotubes have been studied. It is established that the obtained substance possesses an electrical conductivity of 3.34 × 10−4 S/cm at room temperature allowing faster motion of charge carriers. Besides, the unique hierarchical Na2Ti3O7 architecture exhibits promising cycling and rate performance as an anode material for sodium-ion batteries. In particular, after 50 charge/discharge cycles at the current loads of 50, 150, 350, and 800 mA/g, the reversible capacities of about 145, 120, 100, and 80 mA∙h/g, respectively, were achieved. Upon prolonged cycling at 350 mA/g, the capacity of approximately 95 mA∙h/g at the 200th cycle was observed with a Coulombic efficiency of almost 100% showing the retention as high as 95.0% initial storage. At last, it is found that residual water in the un-annealed nanotubular Na2Ti3O7 affects its electrochemical properties.Keywords
Funding Information
- Russian Science Foundation (19-73-10017)
This publication has 65 references indexed in Scilit:
- Titanate Anodes for Sodium Ion BatteriesJournal of Inorganic and Organometallic Polymers and Materials, 2013
- Synthesis of Cu2+ and Ag+ doped Na2Ti3O7 by a facile ion-exchange method as visible-light-driven photocatalystsCeramics International, 2013
- Sodium Storage and Transport Properties in Layered Na2Ti3O7 for Room‐Temperature Sodium‐Ion BatteriesAdvanced Energy Materials, 2013
- Microspheric Na 2 Ti 3 O 7 consisting of tiny nanotubes: an anode material for sodium-ion batteries with ultrafast charge–discharge ratesNanoscale, 2012
- Hydrothermal synthesis of a nanostructured TiO2-based material in the presence of chitosanInorganic Materials, 2012
- First-principle calculations for electronic structure and bonding properties in layered Na2Ti3O7Open Physics, 2011
- Hierarchical nanostructured semiconductor porous materials for gas sensorsJournal of Non-Crystalline Solids, 2010
- Continuous hydrothermal synthesis of extensive 2D sodium titanate (Na2Ti3O7) nano-sheetsDalton Transactions, 2009
- Hydrothermal synthesis of titanate nanotubes followed by electrodeposition processKorean Journal of Chemical Engineering, 2006
- Synthesis and characterization of K2Ti6O13 nanowiresChemical Physics Letters, 2003