A novel fiber‐reinforced polymer rope: Simulation and theoretical investigation
- 23 February 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 45 (8) , 7059-7073
Abstract
The study proposed using twisted rope made of flexible fiber‐reinforced polymers (FRPs) instead of wire and synthetic ropes in high load‐bearing and corrosive environments. Finite element model verification and parameter analysis were conducted for the rope, along with deriving theoretical equations for its tensile properties. Increasing the lay length improved model accuracy, with a maximum bearing capacity within a 10% margin of error compared to experimental results. The model length had minimal impact on calculation results, while changes in radial mesh size (0.13 and 0.2 mm) and friction coefficient (0–0.2) greatly affected maximum contact stress. The tensile strength and elastic modulus of the strand remained almost constant (approximately 1142 MPa and 44 GPa) when the friction coefficient was altered. Increasing lay length (6D–20D) enhanced the tensile properties of the strand, whereas tendon diameter (1–3 mm) had negligible impact. Arranging inner and outer strands with the same lay length was better for circular ropes than those with the same lay angle. Inverse lay direction reduced rope torque and increased strand contact stress. Rectangular ropes had higher strength and modulus conversion efficiency, with lower contact stress compared to circular ones. The accuracy of rope equations improved with longer lay lengths, and adding a correction factor for lay length can modify the equation.Highlights: A flexible FRP rope with high strength and twisted form was proposed. The effect of construction factors on the tensile behaviors of ropes was clarified. Equations for calculating the tensile properties of ropes were derived.Keywords
Funding Information
- Natural Science Foundation of Jiangsu Province (BK20220855)
- National Natural Science Foundation of China (52208233, 52278244)
- China Postdoctoral Science Foundation (2022M720726)
- Fundamental Research Funds for the Central Universities (2242022k30030/2242022k30031/2242022k30033)
This publication has 16 references indexed in Scilit:
- An investigation of fatigue behavior and residual strength model of steel-GFRP composite barComposite Structures, 2023
- A stochastic CSM-based displacement-oriented design strategy for the novel precast SRC-UHPC composite braced-frame in the externally attached seismic retrofittingComposite Structures, 2023
- Experimental measurement for dynamic tension fatigue characteristics of HMPE fibre ropesApplied Ocean Research, 2022
- Optimization of load transfer component for FRP cable anchor systemComposite Structures, 2022
- Evaluation of a large-tonnage FRP cable anchor system: Anchorage design and full-scale experimentEngineering Structures, 2022
- Effect of bending on steel wire rope sling breaking load: Modelling and experimental insightsEngineering Failure Analysis, 2020
- The influence of torsion on braided rope performance, modelling and testsApplied Ocean Research, 2016
- Failure analysis of hoisting steel wire ropeEngineering Failure Analysis, 2014
- Hydrogen embrittlement and corrosion fatigue of corroded bridge wiresJournal of Constructional Steel Research, 2009
- Connecting high-performance carbon-fiber-reinforced polymer cables of suspension and cable-stayed bridges through the use of gradient materialsJournal of Computer-Aided Materials Design, 1996