Dense on Porous Solid LATP Electrolyte System: Preparation and Conductivity Measurement
- 12 September 2016
- journal article
- research article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 100 (1) , 141-149
Abstract
A dense membrane of lithium aluminum titanium phosphate Li 1+ x Al x Ti 2− x ( PO 4 ) 3 , x = 0.3 ( LATP ) is deposited on a porous LATP substrate via wet chemistry. In the polymerized complex process, phosphate precursors with different active groups and steric hindrance are selected to tune precursor's reactivity. Rheological studies and microstructural observations lead to the selection of an LATP powder slurry charged with lithium, aluminum, titanium, and phosphate ion precursors. The optimized formulation is impregnated into a porous LATP substrate. After thermal treatment, dense LATP membranes on top of a porous LATP substrate are obtained with conductivities as high as 3 × 10 −4 S/cm for the dense part, the porous part acting as a mechanical support. An original Van der Pauw impedance setup is validated for the measurement of the ionic conductivity of such dense/porous systems.Keywords
Funding Information
- Agence Nationale de la Recherche
This publication has 31 references indexed in Scilit:
- Crystalline phase content and ionic conductivity correlation in LATP glass–ceramicJournal of Solid State Electrochemistry, 2011
- Electrochemical properties of Li1.4Al0.4Ti1.6(PO4)3 synthesized by a co-precipitation methodJournal of Power Sources, 2011
- All-solid-state lithium battery with a three-dimensionally ordered Li1.5Al0.5Ti1.5(PO4)3 electrodeElectrochimica Acta, 2010
- Investigation of Graded La[sub 2]NiO[sub 4+δ] Cathodes to Improve SOFC Electrochemical PerformanceJournal of the Electrochemical Society, 2010
- Water Durable Lithium Ion Conducting Composite Membranes from the Li[sub 2]O-Al[sub 2]O[sub 3]-TiO[sub 2]-P[sub 2]O[sub 5] Glass-CeramicJournal of the Electrochemical Society, 2007
- Synthesis of Metastable Tetragonal (t′) ZrO 2 ‐12 mol% YO 1.5 by the Organic Polymerized Complex MethodJournal of the American Ceramic Society, 1999
- Ionic Conductivity of Solid Electrolytes Based on Lithium Titanium PhosphateJournal of the Electrochemical Society, 1990
- A dc technique for measurement of solid electrolyte conductivitySolid State Ionics, 1987
- Application of the van der Pauw method to conductivity measurements on mixed ionic-electronic solid conductorsSolid State Ionics, 1982
- Studies in Lithium Oxide Systems: X, Lithium Phosphate CompoundsJournal of the American Ceramic Society, 1961