The effect of strain-induced melt activation process on the microstructure and mechanical properties of Ti-refined A6070 Al alloy
Authors:
- M. EmamyMEM. Emamy
- A. RazaghianARA. Razaghian
- M. KarshenasMKM. Karshenas
- 1 April 2013
- journal article
- Published by Elsevier in Materials & Design (1980-2015)
- Vol. 46, 824-831
Abstract
No abstract availableKeywords
Funding Information
- Iran National Science Foundation
- University of Tehran
This publication has 21 references indexed in Scilit:
- Recrystallization Behavior of 7175 Al Alloy during Modified Strain-Induced Melt-Activated (SIMA) ProcessMATERIALS TRANSACTIONS, 2006
- An investigation on semi-solid Al–7Si–0.3Mg alloy produced by mechanical stirringJournal of Materials Processing Technology, 2005
- Microscopic observation of cold-deformed Al–4Cu–Mg alloy samples after semi-solid heat treatmentsMaterials Characterization, 2005
- Effect of macrostructure and microstructure on the viscosity of the A356 alloy in the semi-solid stateJournal of Materials Processing Technology, 2004
- Mechanical properties and microstructural evaluation of AA5013 aluminum alloy treated in the semi-solid state by SIMA processJournal of Materials Processing Technology, 2004
- Morphological analysis of SSM Al–4.5wt.% Cu measured by the rheocast quality indexJournal of Materials Processing Technology, 2003
- The melting behaviour of extruded Mg–8%Al–2%Zn alloyActa Materialia, 2003
- Characterization of Al 7075 alloys after cold working and heating in the semi-solid temperature rangeJournal of Materials Processing Technology, 2001
- Evolution of near-equiaxed microstructure in the semisolid stateMaterials Science and Engineering: A, 2000
- STRUCTURAL EVOLUTION OF CONVENTIONAL CAST DENDRITIC AND SPRAY-CAST NON-DENDRITIC STRUCTURES DURING ISOTHERMAL HOLDING IN THE SEMI-SOLID STATEScripta Materialia, 1997