Experimental analysis on incoloy 800H superalloy using cryo treated textured inserts with vegetable oil enriched by ZnO nanoparticles
Open Access
- 1 January 2025
- journal article
- Published by FapUNIFESP (SciELO) in Matéria (Rio de Janeiro)
- Vol. 30
Abstract
In this research an effort is made to investigate the machining of Incoloy 800H Super alloy which is hard to machine material due to its rapid hardening property. Laser textured cryogenically treated cutting inserts and vegetable oil enriched with ZnO nano particles through Minimum Quantity Lubrication (MQL) was used. Turning experiments were performed based on L27 Orthogonal Array (OA). Cutting speed, feed rate, and depth of cut were the input parameters. Surface roughness, cutting force, micro hardness, tool-tip temperature, power and material removal rate were the responses measured. Taguchi based Grey Relational Analysis and Analysis of Variance were used to optimize and find the most influencing parameter. The results revealed that the optimal machining conditions were cutting speed at 35 m/min, feed rate at 0.06 mm/rev and depth of cut at 0.5 mm for the multiple-characteristic performances and it was improved by 4.87%. Microhardness, Tool-tip temperature and Power were reduced during machining to 1.31%, 4.53% and 2.10% respectively. Moreover, ZnO nanoparticles enriched base fluid gives better performances in terms of surface roughness, tool wear and cutting force. Furthermore, the White Light Interferometer (WLI) and Scanning Electron Microscopy (SEM) were used to study the machined surface topography and tool wear analysis.Keywords
Funding Information
- the A. P. J. Abdul Kalam Research Centre
- Department of Mechanical Engineering
- Adhi College of Engineering and Technology
- The Carlos Chagas Filho Foundation for Research Support of the State of Rio de Janeiro
This publication has 46 references indexed in Scilit:
- Enhancing machining performance and sustainability: a comprehensive review of minimum quantity lubricationJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2025
- Evaluation of specific cutting energy, tool wear, and surface roughness in dry turning of titanium grade 3 alloyThe International Journal of Advanced Manufacturing Technology, 2023
- Multi-objective optimization of turning titanium-based alloy Ti-6Al-4V under dry, wet, and cryogenic conditions using gray relational analysis (GRA)The International Journal of Advanced Manufacturing Technology, 2020
- Optimization of Turning Parameters of Machining Incoloy 800H Superalloy Using Cryogenically Treated Multilayer CVD-Coated ToolArabian Journal for Science and Engineering, 2018
- Effects of nano-cutting fluids on tool performance and chip morphology during machining Inconel 718The International Journal of Advanced Manufacturing Technology, 2018
- Taguchi-based grey relational analysis for modeling and optimizing machining parameters through dry turning of Incoloy 800HJournal of Mechanical Science and Technology, 2017
- Experimental study on the cutting temperature of textured carbide tool embedded with graphiteThe International Journal of Advanced Manufacturing Technology, 2017
- Experimental assessment of derivative cutting of micro-textured tools in dry cutting of medium carbon steelsThe International Journal of Advanced Manufacturing Technology, 2017
- Analysis of dimple textured surfaces on cutting toolsJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2016
- Tool wear and tool life in end milling of 15–5 PH stainless steel under different cooling and lubrication conditionsThe International Journal of Advanced Manufacturing Technology, 2008