Analysis of the thermally stimulated discharge current around glass-rubber transition temperature in polyethylene terephthalate
Authors:
- 1 September 1997
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 82 (5) , 2488-2496
Abstract
The nature of the thermally stimulated discharge current (TSDC) for polyethylene terephthalate samples in the temperature range from room temperature to above glass-rubber transition temperature of the amorphous phase is analyzed. The well conditioning of the sample is strictly necessary in order to have a good reproducibility and accuracy of results. A main peak was observed whose maximum temperature moves towards a lower value with the decreasing of the amount of charge that flows through the sample during polarization. The peak position changes as well, if the sample is polarized in air or in oxygen and the nature of change is more important in the case of oxygen. The shape of the peak is complex and at least four shoulders have been identified around 85, 90, 105, and 125 °C using the cleaning technique. The activation energy tends to increase with repetition of the TSDC runs, in the glass-rubber transition temperature range, in the case when the cleaning technique is used for the peaks separation. For the conditioned samples, there is a good agreement between the experimental results and the analytical expression of the current, particularly in the region where it reaches a maximum, and so relevant values for the characteristic parameters of the peak are determined. The time interval of the short circuiting of the sample, at room temperature, before the TSDC measurement, strongly influences the initial rise of the current and consequently the parameters of the peak. A possible redistribution of the internal field arising from the injected charge, the heterocharge, and the existing charge in the sample as received, has been put forward to account for the experimental evidences. The conclusion is that the current is mainly determined by the space-charge released from the traps that are likely continuously distributed in energy. For the stated polarization conditions, the charge is released from the shallow traps with an activation energy in the range 0.23–0.32 eV and a concentration of The dipolar charge is of little importance.
Keywords
This publication has 19 references indexed in Scilit:
- Origins of thermally stimulated current in polyethersulfoneIEEE Transactions on Dielectrics and Electrical Insulation, 1996
- Characterization of polyester films used in capacitors. II. Effects of heat treatments on transient and steady-state charging currents in polyethylene terephthalate thin filmsJournal of Applied Physics, 1994
- Dielectric relaxations in drawn semi-crystalline poly(ethylene terephthalate)Journal of Non-Crystalline Solids, 1994
- Heat treatment effects on the metal-polymer interface and space-charge formation in thin metallized polyethylene terephthalate filmsJournal of Applied Physics, 1994
- Peak parameters from peak area to height ratio in thermally stimulated depolarization and thermoluminescenceJournal of Applied Physics, 1988
- Thermally stimulated current and creep in poly(ethylene terephthalate)Journal of Applied Physics, 1979
- Thermally Stimulated Currents from Non-Treated Poly(ethlene Terephthalate) FilmsJapanese Journal of Applied Physics, 1978
- On the nature of absorption currents in polyethyleneterephthalate (PET)Journal of Physics D: Applied Physics, 1976
- Thermal Current Study of the Effect of Humidity on Charge Storage in MylarJournal of Applied Physics, 1971
- Ionic Thermocurrents in DielectricsPhysical Review B, 1966