Investigation of over-bending defect in the cold roll forming of U-channel section using experimental and numerical methods
- 1 March 2022
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 236 (10) , 1380-1392
Abstract
In spite of product quality increase in the cold roll forming process by previous practical researches for defects prevention, there are some ill-considered defects such as over-bending, which diminished the product quality in the open section products of this process. This defect which happens by superfluous bending of sheet in the forming stand not only lead to defective products, but also trigger other defects such as edge wrinkling. Since in an elaborate process such as cold roll forming, forming parameters play an active role in defect prevention, the effect of some important parameters is investigated on the over-bending defect and product bending angle by doing 68 experimental tests and numerical simulations in the present study. The list of parameters which are investigated includes bend angle increment, flange width, strip thickness, radius of bend, strength of the materials, and inter-distance between successive stands. In addition, the reason behind the effect of each parameter on the accuracy of the bending angle is laid out. Results show that over-bending defect can be compensated or even eliminated by decreasing the bending angle in each stand, a technique called bending angle increment. Increasing the number of forming stands from two to five causes the over-bending to decrease from 6° to 0°. With bending angle increment being the most impactful factor, bending radius, flange width, and strip thickness have a decreasing impact on over-bending. This study also brings forward a reverse relationship between the strength of the material and the intensity of over-bending. The inter-distance between successive stands was found to have the least effect on over-bending. Results highlight the importance of pre-form rolls at the beginning of the roll forming line. Without the usage of pre-form rolls, the folding of strips on a 60° angle, cannot be done in one stand.Keywords
This publication has 34 references indexed in Scilit:
- Product defect compensation by robust optimization of a cold roll forming processJournal of Materials Processing Technology, 2013
- Forming Limit Diagram Prediction of Tailor-Welded Blank Using Experimental and Numerical MethodsJournal of Materials Engineering and Performance, 2012
- Investigation of the effect of roll forming pass design on main redundant deformations on profiles from AHSSThe International Journal of Advanced Manufacturing Technology, 2011
- Optimization design of roll profiles for cold roll forming based on response surface methodMaterials & Design (1980-2015), 2009
- Investigation of the effects of main roll-forming process parameters on quality for a V-section profile from AHSSThe International Journal of Advanced Manufacturing Technology, 2008
- Prediction and inline compensation of springback in roll forming of high and ultra-high strength steelsProduction Engineering, 2008
- Experimental investigations of the roll load and roll torque when high strength steel is roll formedJournal of Materials Processing Technology, 2007
- Cold roll forming of a U-channel made of high strength steelJournal of Materials Processing Technology, 2007
- Localised edge buckling in cold roll-forming of symmetric channel sectionThin-Walled Structures, 2006
- A new criterion to predict necking failure under biaxial stretchingJournal of Materials Processing Technology, 1994