Top-down Determination of Fluctuations in Topographic Measurements
Open Access
Abstract
A top-down method is presented and studied for quantifying topographic map height (z) fluctuations directly from measurements on surfaces of interest. Contrary to bottom-up methods used in dimensional metrology, this method does not require knowledge of transfer functions and fluctuations of an instrument. Fluctuations are considered here to be indicative of some kinds of uncertainties. Multiple (n), successive topographic measurements (z = z(x,y)) are made at one location without moving the measurand relative to the measurement instrument. The measured heights (z) at each position (x,y) are analyzed statistically. Fluctuation maps are generated from the calculated variances. Three surfaces were measured with two interferometric measuring microscopes (Bruker ContourGT™ and Zygo NewView™ 7300). These surfaces included an anisotropic, turned surface; an isotropic, sandblasted surface; and an abraded, heterogeneous, multilayer surface having different, complex, multiscale morphologies. In demonstrating the method, it was found that few non-measured points persisted for all 100 measurements at any location. The distributions of uncertainties are similar to those of certain features on topographic maps at the same locations, suggesting that topographic features can augment measurement fluctuations. This was especially observed on the abraded ophthalmic lens; a scratch divides the topographic map into two zones with different uncertainty values. The distributions of fluctuations can be non-Gaussian. Additionally, they can vary between regions within some measurements.Keywords
Funding Information
- ELSAT2020 Project
This publication has 34 references indexed in Scilit:
- Quantification of first contact detection errors on hardness and indentation size effect measurementsTribology International, 2013
- Influence of surface roughness on the optical properties of plasmonic nanoparticlesPhysical Review B, 2011
- Methods for determining and processing 3D errors and uncertainties for AFM data analysisMeasurement Science and Technology, 2011
- Roughness characteristic length scales of belt finished surfaceJournal of Materials Processing Technology, 2009
- Multiscale roughness analysis in injection‐molding processPolymer Engineering & Science, 2008
- Roughness characteristic length scales of micro-machined surfaces: A multi-scale modellingSensors and Actuators B: Chemical, 2007
- A numerical method to calculate the Abbott parameters: A wear applicationTribology International, 2007
- Probing systems for dimensional micro- and nano-metrologyMeasurement Science and Technology, 2006
- Effects of finite stylus width in surface contact profilometryApplied Optics, 1993
- Assessing the Effect of Stylus Tip Radius and Flight on Surface Topography MeasurementsJournal of Tribology, 1984