Inclination Angle Effect on the Thickness Distribution in a Superplastic Formed Long Rectangular Pan
- 27 December 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 735, 155-161
Abstract
In the superplastic process, the non-uniformity of the produced part thickness and the possibility of severe thinning are among the major disadvantages. This paper presents a parametric study on the superplastic forming of a Pb-Sn sheet into the shape of a long rectangular pan. A two dimensional plain strain finite element model was used to predict the forming times and thinning profiles of the formed Pb-Sn pan. The effect of varying the sidewall inclination angle was investigated for different friction conditions at the die-sheet interface. Results showed that increasing the side wall inclination angle reduced the forming time and provided a better thickness distribution.Keywords
This publication has 6 references indexed in Scilit:
- New approach to gas pressure profile prediction for high temperature AA5083 sheet formingJournal of Materials Processing Technology, 2010
- Simulation of High-Temperature AA5083 Bulge Forming with a Hardening/Softening Material ModelJournal of Materials Engineering and Performance, 2008
- Simulation of instability during superplastic deformation using finite element methodMaterials & Design (1980-2015), 2005
- Optimum Forming Loading Paths for Pb-Sn Superplastic Sheet MaterialsJournal of Engineering Materials and Technology, 1999
- Superplastic process modeling of plane strain components with complex shapesJournal of Materials Shaping Technology, 1991
- An analysis of the bulging of a superplastic sheet by lateral pressureInternational Journal of Mechanical Sciences, 1970