Effect of Orientation, Thickness, and Composition on Properties of Ductile Iron Castings
- 7 January 2013
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 28 (5) , 539-544
Abstract
In this work, the effects of casting orientation (horizontal, side, and vertical), section thickness (4–16 mm) and composition (Cu, Mn) were investigated on the cooling rate, microstructure, and mechanical properties (tensile strength, yield strength, elongation, hardness) of hypereutectic ductile iron castings. Overall, horizontal castings were found to cool faster than side and vertical castings. Thermal analysis (using cooling curves) showed a wide difference among the four sections. Thinner sections exhibited significant undercooling and thereby carbide formation, leading to poor ductility. The combined effect of Cu and Mn showed an increase in the amount of pearlite to 82% and nodularity to 94% along with a reduction in nodule count to 323 and the amount of ferrite. Also, increased tensile strength (659 MPa) and hardness (264 BHN) were observed along with a drop in ductility to 2.5% in 4 mm thin section, helping offset carbide formation. Thermal analysis was found to be a useful tool in understanding the combined effect of orientation, thickness variations and processing parameters.Keywords
This publication has 15 references indexed in Scilit:
- Effect of Casting Design to Microstructure and Mechanical Properties of 5 mm TWDI PlateApplied Mechanics and Materials, 2012
- Effect of Selected Alloying Elements on Mechanical Properties of Pearlitic Nodular Cast IronsKey Engineering Materials, 2010
- Influence of Cooling Rate and Alloying Elements on Kinetics of Eutectoid Transformation in Spheroidal Graphite Cast IronKey Engineering Materials, 2010
- The Effects of Nodularity Distribution on Vertical Configuration Mould for Automotive Ductile Iron CastingAdvanced Materials Research, 2010
- Solidification of Thin Wall Ductile Iron Castings with Hypereutectic CompositionISIJ International, 2010
- Influence of nodule count on residual stresses and distortion in thin wall ductile iron plates of different matricesJournal of Materials Processing Technology, 2009
- Temperature measurement during solidification of thin wall ductile cast iron. Part 1: Theory and experimentMeasurement, 2008
- On the mechanisms of copper effect on structure formation in cast ironMetal Science and Heat Treatment, 2007
- Influence of an appropriate balance of the alloying elements on microstructure and on mechanical properties of nodular cast ironJournal of Materials Processing Technology, 2005
- Mechanical Properties of Thin Wall Ductile Iron-Influence of Carbon Equivalent and Graphite DistributionISIJ International, 2004