Searching for a Numerical Model for Prediction of Pressure-Swirl Atomizer Internal Flow
Open Access
- 22 June 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (13) , 6357
Abstract
Numerical prediction of discharge parameters allows design of a pressure-swirl atomizer in a fast and cheap manner, yet it must provide reliable results for a wide range of geometries and operating regimes. Many authors have used different numerical setups for similar cases and often concluded opposite suggestions on numerical setup. This paper compares 2D (two-dimensional) axisymmetric, 3D (three-dimensional) periodic and full 3D numerical models used for estimation of the internal flow characteristics of a pressure-swirl atomizer. The computed results are compared with experimental data in terms of spray cone angle, discharge coefficient (CD), internal air-core dimensions, and velocity profiles. The three-component velocity was experimentally measured using a Laser Doppler Anemometry in a scaled transparent model of the atomizer. The internal air-core was visualized by a high-speed camera with backlit illumination. Tested conditions covered a wide range of the Reynolds numbers within the inlet ports, Re = 1000, 2000, 4000. The flow was treated as both steady and transient flow. The numerical solver used laminar and several turbulence models, represented by k-ε and k-ω models, Reynolds Stress model (RSM) and Large Eddy Simulation (LES). The laminar solver was capable of closely predicting the CD, air-core dimensions and velocity profiles compared with the experimental results in both 2D and 3D simulations. The LES performed similarly to the laminar solver for low Re and was slightly superior for Re = 4000. The two-equation models were sensitive to proper solving of the near wall flow and were not accurate for low Re. Surprisingly, the RSM produced the worst results.Keywords
Funding Information
- Operational Programme Research, Development and Education (CZ.02.1.01/0.0/0.0/16_026/0008392)
This publication has 25 references indexed in Scilit:
- Viscous flow through the swirl chamber of a pressure-swirl atomizerInternational Journal of Multiphase Flow, 2013
- Numerical investigation of volume of fluid and level set interface capturing methods for bubble growth and detachmentJournal of Physics: Conference Series, 2012
- Numerical Simulation of Laminar and Turbulent Two-Phase Flow in Pressure-Swirl AtomizersAIAA Journal, 2012
- AN APPRAISAL OF SWIRL ATOMIZER INVISCID FLOW ANALYSIS, PART 2: INVISCID SPRAY CONE ANGLE ANALYSIS AND COMPARISON OF INVISCID METHODS WITH EXPERIMENTAL RESULTS FOR DISCHARGE COEFFICIENT, AIR CORE RADIUS, AND SPRAY CONE ANGLEAtomization and Sprays, 2009
- AN APPRAISAL OF SWIRL ATOMIZER INVISCID FLOW ANALYSIS, PART 1: THE PRINCIPLE OF MAXIMUM FLOW FOR A SWIRL ATOMIZER AND ITS USE IN THE EXPOSITION AND COMPARISON OF EARLY FLOW ANALYSESAtomization and Sprays, 2009
- CFD Analysis of Swirl Atomizers2008
- A numerical and experimental investigation on the coefficients of discharge and the spray cone angle of a solid cone swirl nozzleExperimental Thermal and Fluid Science, 2004
- Initiation of air core in a simplex nozzle and the effects of operating and geometrical parameters on its shape and sizeExperimental Thermal and Fluid Science, 2002
- Prediction of Velocity Coefficient and Spray Cone Angle for Simplex Swirl AtomizersInternational Journal of Turbo & Jet-Engines, 1987
- Internal flow characteristics of simplex swirl atomizersJournal of Propulsion and Power, 1985