Vibration testing for dynamic properties of building floors
Open Access
- 1 June 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 869 (5)
Abstract
The paper presents a comparison of testing methods and post processing techniques for modal properties of a fully furnished chipboard floor and an unfurnished prestressed concrete floor. A thorough modal testing required relocation of transducers among test setups to acquire multiple synchronous measurements of floor response due to heel drop excitation or shaker excitation. The comprehensive experimental data was processed by a specialised operational modal analysis software. On the other hand, a simple testing approach only required records of floor response at a single point due to heel drop. The measured response can be easily analyzed using simple procedures of structural dynamics. Whilst valuable information about the floor modal properties including the mode shapes was obtained using the sophisticated approach, the uncomplicated single-point heel drop test was found to provide reasonably accurate evaluation of natural frequencies and damping ratios for both of the test floors, which verifies the attractiveness of the simple technique. Based on experimental results, both of the floors would be considered as low-frequency floors by commonly used guidelines on human-induced floor vibrations. Furthermore, the effect of fit-out conditions and construction materials on the huge discrepancy between damping values of the two floors was also observed.Keywords
This publication has 5 references indexed in Scilit:
- Multi-Shaker Modal Testing and Modal Identification of Hollow-Core Floor System2016
- USE OF A FORCE PLATE VERSUS ARMATURE ACCELEROMETER FOR MEASURING FREQUENCY RESPONSE FUNCTIONSExperimental Techniques, 2009
- DYNAMIC TESTING AND MONITORING OF CIVIL ENGINEERING STRUCTURESExperimental Techniques, 2008
- Dynamic Measurements of In-Place Steel Floors to Assess Vibration PerformanceJournal of Performance of Constructed Facilities, 2003
- IMPULSE HAMMER VERSUS SHAKER EXCITATION FOR THE MODAL TESTING OF BUILDING FLOORSExperimental Techniques, 2000