High-Performance HfO2/Al2O3 Superlattice MIM Capacitor in a 200 mm High-Volume Batch-ALD Platform
- 26 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 2036-2042
Abstract
We have developed a superlattice structure (SLS) of HfO $_{\text{2}}$ and Al $_{\text{2}}$ O $_{\text{3}}$ high- k dielectrics by high-volume batch atomic layer deposition on a 200 mm platform. The SLS forms a hafnium aluminate (Hf $_{\text{1-x}}$ Al $_{\text{x}}$ O) alloy at deposition temperature and presents superior electrical properties as a metal-insulator-metal (MIM) capacitor. Among the samples, an Al mole fraction of $\sim$ 0.31 demonstrates the highest capacitance density ( C $_{\textit{p}}$ D ) of 12.46 fF/ $\mu $ m $^{\text{2}}$ and dielectric constant, $\kappa $ $>$ 22, 2% better than HfO $_{\text{2}}$ . A higher Al mole fraction of 0.56 shows a superior quadratic component ( $\alpha $ ) of voltage-coefficient of capacitance and 68% higher- $\kappa $ than an Al $_{\text{2}}$ O $_{\text{3}}$ capacitor. Electrical measurement before and after annealing at 650 $^{\circ}$ C for 30 s illustrates the thermal stability of capacitors. The present research indicates a small amount of Al incorporation in HfO $_{\text{2}}$ extends its quantization temperature by stabilizing the crystal phase by reducing oxygen vacancies and traps. It remarkably improved electrical characteristics under thermal stress compared to broken-down HfO $_{\text{2}}$ capacitors under annealing. Besides, the alloy also shows improved linearity over a broad frequency range, lower leakage current, and a breakdown electric field ( E $_{\text{BV}}$ ) in the order of 4 MV/cm. At the same time, higher Al incorporation provides the highest E $_{\text{BV}}$ of $\sim$ 8 MV/cm, low leakage, and near principle $\alpha $ of 210 ppm/V $^{\text{2}}$ with better thermal stability. These thin multilayer SLS alloys show excellent relative capacitance variation over the voltage with high C $_{\textit{p}}$ D , $\kappa $ , low leakage of 10 nA/cm $^{\text{2}}$ at 3 MV/cm, suitable for higher thermal budget and interposer process integration for various high bandwidth RF and low-cost memory applications with smaller chip area.Keywords
Funding Information
- Tokyo Electron Ltd
- Skywater Technology
- BRIDG. The review of this article was arranged by Editor J. F. Conley
This publication has 30 references indexed in Scilit:
- Comparison of on-chip MIS capacitors based on stacked HfO2/Al2O3 nanolaminatesMaterials Today Communications, 2022
- Potential solution-induced HfAlO dielectrics and their applications in low-voltage-operating transistors and high-gain invertersRSC Advances, 2018
- Characterization of Al2O3–HfO2–Al2O3 sandwiched MIM capacitor under DC and AC stressesSolid-State Electronics, 2013
- Analysis of reliability characteristics of high capacitance density MIM capacitors with SiO2–HfO2–SiO2 dielectricsMicroelectronic Engineering, 2011
- Effect of film composition and structure on the crystallization point of atomic layer deposited HfAlOx using metal (diethylamino) precursors and ozoneActa Materialia, 2008
- Investigation of optical and electronic properties of hafnium aluminate films deposited by Metal–Organic Chemical Vapour DepositionThin Solid Films, 2006
- Impact of Al incorporation in hafnia on interface states in (100)Si/HfAlxOyMicroelectronic Engineering, 2005
- Electrical characterisation and reliability of HfO2 and Al2O3–HfO2 MIM capacitorsMicroelectronics Reliability, 2003
- Morphology and crystallization kinetics in HfO2 thin films grown by atomic layer depositionJournal of Applied Physics, 2003
- Energy gap and band alignment for (HfO2)x(Al2O3)1−x on (100) SiApplied Physics Letters, 2002