A comparison study of water diffusion in unidirectional and 2D woven carbon/epoxy composites
- 22 October 2021
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 43 (1) , 118-129
Abstract
The use of CFRP composites is significantly increasing in the aerospace, automotive, and marine industries, particularly in safety critical primary structures. This work presents a newly developed experimental approach to investigate the directional diffusion of water in CFRP composites with the use of Fick's law. The approach is used to study the effect of fiber architecture on directional diffusion rates, with a particular focus on the role of fiber waviness in the diffusion process. A comparison of water diffusion is made in three different fiber architectures: Unidirectional (UD), plain weave, and twill weave. The specimens were fully immersed in 90°C purified water until their maximum moisture saturation was achieved, with some specimens being selectively exposed from the edges only to obtain the directional diffusion coefficients. The water penetration process into the CFRP structure initiate from the micro‐cracks and defects. The experimental work of this study shows sharp mass increases within the first stage followed by an equilibrium stage where saturation is present. The interfacial region is found to be a critical parameter where detachment of the interfacial fiber/matrix bonding is observed further demonstrating the potential effect of different fiber architecture in this region. UD fiber architecture showed ~20% higher diffusion coefficient in the Dx,y direction compared with plain and twill woven architectures. The weave patterns in 2D woven fiber architectures are therefore believed to play a key role on the moisture ingress mechanism and subsequently contributed in slowing down the capillary process in the interfacial region. This has implications for materials development and selection for CFRP composites used in moist environments.Keywords
This publication has 46 references indexed in Scilit:
- Investigation of the long term effects of moisture on carbon fibre and epoxy matrix compositesComposites Science and Technology, 2012
- Effects of hygrothermal environmental conditions on compressive strength of CFRP stitched laminatesJournal of Reinforced Plastics and Composites, 2010
- Accelerated aging versus realistic aging in aerospace composite materials. V. The effects of hot/wet aging in a structural epoxy compositeJournal of Applied Polymer Science, 2009
- Damage evolution behavior of CFRP laminates under post-impact fatigue with water absorption environmentComposites Science and Technology, 2009
- Tensile behaviours of quartz, aramid and glass filaments after NaCl treatmentMaterials & Design (1980-2015), 2009
- Interface damage study of hydrothermally aged glass-fibre-reinforced polyester compositesComposites Science and Technology, 1999
- Biologically mediated dissolution of glassChemical Geology, 1995
- Factors Affecting Moisture Absorption in Polymer Composites Part I: Influence of Internal FactorsJournal of Reinforced Plastics and Composites, 1984
- Factors Affecting Moisture Absorption in Polymer Composites Part II: Influence of External FactorsJournal of Reinforced Plastics and Composites, 1984
- Langmuir-Type Model for Anomalous Moisture Diffusion In Composite ResinsJournal of Composite Materials, 1978