Reciprocating wear mechanisms in a Zr-based bulk metallic glass
Authors:
- 1 September 2006
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 22 (2) , 264-273
Abstract
The dry sliding friction coefficient μ and the wear volume loss W, in a zirconium-based bulk metallic glass (BMG) under high-frequency (50 Hz) reciprocating conditions, were investigated with the objective of assessing the influence of free volume and crystallization on the wear behavior of amorphous metals. The BMG samples were annealed either below the glass transition temperature Tg to induce structural relaxation and hence reduce the free volume that controls plasticity through shear-band formation or above Tg to crystallize the amorphous BMG prior to wear testing. Results show that the wear behavior of both the as-cast and relaxed glasses was dominated by the oxidation of the surface layers. A sharp transition in the contact electrical resistance complemented by a marked increase in μ was noted. This was attributed to the formation of a thick tribo film with high oxygen concentration and its subsequent delamination. The μ values, before as well as after the transition, in the relaxed glasses were similar to those for the as-cast alloy. However, a gradual decrease in W with annealing temperature was observed. A good correlation between W and nanohardness was noted, implying that the intrinsic hardness in the BMGs controlled the wear rate.Keywords
This publication has 29 references indexed in Scilit:
- Hardness and plastic deformation in a bulk metallic glassActa Materialia, 2005
- Bulk metallic glassesMaterials Science and Engineering: R: Reports, 2004
- Correlation between enthalpy change and free volume reduction during structural relaxation of Zr55Cu30Al10Ni5 metallic glassScripta Materialia, 2004
- Microhardness and abrasive wear resistance of metallic glasses and nanostructured composite materialsJournal of Non-Crystalline Solids, 2003
- Wear behavior of bulk Zr41Ti14Cu12.5Ni10Be22.5 metallic glassesJournal of Materials Research, 2002
- Rate Dependence of Serrated Flow During Nanoindentation of a Bulk Metallic GlassJournal of Materials Research, 2002
- Friction and wear of a Zr-based amorphous metal alloy under dry and lubricated conditionsWear, 2001
- Bulk metallic glassesJournal of Physics: Condensed Matter, 2001
- Wear behaviour of rapidly solidified Fe68Cr18Mo2B12 alloysWear, 1994
- A microscopic mechanism for steady state inhomogeneous flow in metallic glassesActa Metallurgica, 1977