One-step spray of Cu2NiSnS4 thin films as absorber materials for photovoltaic applications
Authors:
Open Access
- 4 April 2020
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (9) , 7193-7199
Abstract
A simple one-step «Spray Pyrolysis» technique was developed for preparing Cu2NiSnS4 (CNTS) thin film followed by an annealing treatment process. Originally, the spray technique was successfully used to deposit the thin film onto glass substrate at 250 °C for 60 min spray duration. Again, the deposited thin film was annealed in a sulfur atmosphere at a temperature of 500 °C during 30 min. The sulfured thin film exhibits (111), (220) and (311) orientations correspond well to the cubic CNTS structure and other impurity compounds. The SEM data exhibit a uniform, rough and compact topography of CNTS thin films with an average-thickness of 1.36 µm. The absorption coefficient is found to be higher than 104 cm−1 in the visible region while the direct band energy of 1.62 eV, which is eminently suitable for use as an absorber in the solar cell. The complex impedance diagrams indicate the decrease of resistance by increasing temperature, which attributes to a semiconductor behavior. The close values of activation energies 0.63 and 0.54 eV determined from both angular frequency and DC conductivity indicate that the carrier transport mechanism is thermally activated.Keywords
This publication has 26 references indexed in Scilit:
- Synthesis of quaternary Cu 2 NiSnS 4 thin films as a solar energy material prepared through «spray» techniqueMaterials Letters, 2017
- Photo-electrochemical properties and electronic band structure of kesterite copper chalcogenide Cu2–II–Sn–S4 (II = Fe, Co, Ni) thin filmsRSC Advances, 2016
- Quaternary Cu2NiSnS4 thin films as a solar material prepared through electrodepositionMaterials Letters, 2016
- Structural, optical and magnetic properties of Cu2NiSnS4 thin films deposited by facile one-step electrodepositionMaterials Letters, 2016
- Earth-abundant quaternary semiconductor Cu 2 MSnS 4 (M = Fe, Co, Ni and Mn) nanofibers: Fabrication, characterization and band gap arrangementJournal of Alloys and Compounds, 2016
- Optical and thermoelectric properties of chalcogenide based Cu2NiSnS4 nanoparticles synthesized by a novel hydrothermal routeMaterials Letters, 2015
- Nanoconfined Solvothermal Synthesis and Characterization of Ultrafine Cu2NiSnS4 NanotubesChempluschem, 2015
- Synthesis of Cu2NiSnS4 nanoparticles by hot injection method for photovoltaic applicationsMaterials Letters, 2014
- Flower-like Cu2NiSnS4 nanoparticles synthesized by a facile solvothermal methodMaterials Letters, 2014
- A general strategy for synthesis of quaternary semiconductor Cu2MSnS4 (M = Co2+, Fe2+, Ni2+, Mn2+) nanocrystalsJournal of Materials Chemistry, 2012