Partitioned register file for TTAs
Authors:
- H. CorporaalHCH. Corporaal
- 1 November 1995
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 303-312
Abstract
A practical implementation of high performance instruction level parallel architectures is constrained by the difficulty to build a large monolithic multi-ported register file (RF). A solution is to partition the RF into smaller RFs while keeping the total number of registers and ports equal. This paper applies RF partitioning to transport triggered architectures (TTAs); these architectures are of the VLIW type. One may expect that partitioning increases the number of executed cycles because it constrains the number of ports per RF. It is shown that these performance losses are small; e.g. partitioning an RF with 24 registers and four read and four write ports into four RFs with 6 registers and one read and one write port gives a performance loss of only 5.8%. Partitioned RFs consume less area than monolithic RFs with the same number of ports and registers. Experiments show that, if the area saved by partitioning is spent on extra registers, partitioning does, on average, not reduce the performance; it may even result in a small performance gain.Keywords
This publication has 8 references indexed in Scilit:
- Register file port requirements of transport triggered architectures1994
- Transport-triggering vs. operation-triggering1994
- Move32int, a sea of gates realization of a high performance transport triggered architectureMicroprocessing and Microprogramming, 1993
- Instruction-level experimental evaluation of the Multiflow TRACE 14/300 VLIW computerThe Journal of Supercomputing, 1993
- An analytical access time model for on-chip cache memoriesIEEE Journal of Solid-State Circuits, 1992
- Global instruction scheduling for superscalar machines1991
- MOVE: a framework for high-performance processor design1991
- Register allocation via coloringComputer Languages, 1981