Influence of cooling rate on the properties of carbon fiber unidirectional composites with polypropylene, polyamide 6, and polyphenylene sulfide matrices
- 6 August 2019
- journal article
- research article
- Published by Taylor & Francis in Advanced Composite Materials
- Vol. 29 (1) , 101-113
Abstract
The longitudinal and transverse strength of three unidirectional thermoplastic prepreg systems: carbon fiber/polypropylene (CF/PP), polyamide 6 (CF/PA6), and polyphenylene sulfide (CF/PPS) are studied and analytical formulas are proposed for the estimation of matrix and fiber/matrix interface properties from composites properties. Since the matrices are semi-crystalline thermoplastics, the influence of cooling rate on the strength is statistically evaluated. While the 0º tensile strength is found to be independent of the cooling rate, the 90º tensile strength is strongly influenced by the matrix type and cooling rate. The matrix modulus increases as the cooling rate is decreased; the degree of crystallinity also increases. The matrix residual stress, interfacial shear strength, and mode II interlaminar fracture toughness are also found to depend on the cooling rate, with the trends different for different matrices.Keywords
This publication has 30 references indexed in Scilit:
- Interfacial shear strength of a glass fiber/epoxy bonding in composites modified with carbon nanotubesComposites Science and Technology, 2010
- Investigation of load bearing performances of pin connected carbon/polyphenylene sulphide composites under static loading conditionsMaterials & Design (1980-2015), 2007
- The use of a single-fibre pull-out test to investigate the influence of acidic and basic surface groups on carbon fibres on the adhesion to poly(phenylene sulfide) and matrix-morphology-dependent fracture behaviourComposites Science and Technology, 2001
- Interfacial shear strength and failure modes in sPP/CF and iPP/CF microcomposites by fragmentationPolymer, 2001
- Flexural failure mechanisms in injection-moulded carbon fibre/PEEK compositesComposites Science and Technology, 2000
- The measurement and prediction of residual stresses in carbon-fibre/polymer compositesComposites Science and Technology, 1997
- Matrix morphology and fibre pull-out strength of T700/PPS and T700/PET thermoplastic compositesJournal of Materials Science, 1995
- The influence of moulding conditions on delamination behaviour of carbon-fibre/peak compositesComposites Science and Technology, 1994
- Polyetheretherketone (PEEK): Processing‐structure and properties studies for a matrix in high performance compositesPolymer Composites, 1986
- Thermal Expansion Coefficients of Composite Materials Based on Energy PrinciplesJournal of Composite Materials, 1968