Abstract
In our discussion of the equilibrium concentration of point defects in Chapter 5, we have assumed that for a given crystal there is only one type of defect with non-negligible concentration. We now discuss the scenario in which multiple types of point defects coexist in the same crystal. In Section 6.1, we show that the open crystal structure of silicon allows both vacancies and self-interstitials to exist with appreciable concentrations at thermal equilibrium. In Section 6.2, we discuss strongly ionic solids, in which all point defects are charged, and the charge neutrality condition requires point defects to be created in pairs. The equilibrium point defect concentration can be obtained by minimizing the Gibbs free energy of the crystal, or, alternatively, by the method of chemical equilibrium, each subjected to the charge neutrality condition. In Section 6.3, we discuss nonstoichiometric ionic solids in which atomic point defects can exist in both charged or neutral states, and electronic defects can also be present. The concentration of various atomic and electronic defects can be controlled by the partial pressures in the vapor phase. In Section 6.4, we show that the type of the dominant point defect in intermetallic compounds, such as Ni–Al alloys, can change with composition. In Section 6.5, we discuss the formation of vacancy clusters. When a crystal is quenched from a high temperature to a low temperature, there is not sufficient time for vacancies to reach the true equilibrium concentration at the low temperature, and they tend to form clusters instead. We show that the thermodynamic principles can be applied to predict the concentration of vacancy clusters in the state where the total number of vacant sites is constrained. Vacancies and self-interstitials in Si Most of our discussion so far has concerned close-packed metals where vacancies can form but where self-interstitials are so energetic that they are essentially never present (except for metals irradiated by energetic particles like neutrons). On the other hand, the open crystal structure of Si (see Chapter 1) allows self-interstitials to form relatively easily. There is enough room in some interstitial positions to allow Si atoms (treated as spheres) to fit into the interstitial sites with no distortion at all (see Exercise problem 4.2).