Diesel Engine Indicated and Load Torque Estimation Using a Non-Linear Observer
- 1 June 2006
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 220 (6) , 775-785
Abstract
This paper presents a non-linear observer to estimate the indicated torque and the load torque of a single-cylinder diesel engine from crankshaft and coupling angular velocity measurements. Since these variables can be measured using low-cost sensors, the observer may be useful in the implementation of the control or diagnostics strategies that require cylinder indicated torque and load torque, variables that are not easily measured and need expensive sensors. The observer operates in the crank angle domain and is based on a nonlinear dynamic engine model that includes an instantaneous friction model. The effects of inertia variations of the crankshaft assembly with piston pin offset are also included, which significantly increases the accuracy of the pressure estimation at high speeds. Strong chattering is avoided by modifying the sliding gain as a non-linear function of the crank angle. The stability of the observer is proved, and simulation results of the engine indicated torque and load torque are presented, which indicate good agreement with experimental data.Keywords
This publication has 19 references indexed in Scilit:
- Detailed analytical model of a single-cylinder diesel engine in the crank angle domainProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2001
- Instantaneous friction components model for transient engine operationProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2000
- Design of An IC Engine Torque Estimator Using Unknown Input ObserverJournal of Dynamic Systems, Measurement, and Control, 1999
- Dynamic simulation of a single-cylinder diesel engine including dynamometer modelling and frictionProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1999
- Event-based estimation of indicated torque for IC engines using sliding-mode observersControl Engineering Practice, 1997
- Application of nonlinear sliding-mode observers for cylinder pressure reconstructionControl Engineering Practice, 1997
- Identification of a non-linear internal combustion engine model for on-line indicated torque estimationMechanical Systems and Signal Processing, 1994
- Variable structure control: a surveyIEEE Transactions on Industrial Electronics, 1993
- Estimate of indicated torque from crankshaft speed fluctuations: a model for the dynamics of the IC engineIEEE Transactions on Vehicular Technology, 1989
- Variable structure systems with sliding modesIEEE Transactions on Automatic Control, 1977