Comparison of the Mechanical Properties of Single Crystal and Polycrystalline Yttrium Aluminum Garnet
Authors:
- 1 March 2006
- journal article
- Published by Wiley in International Journal of Applied Ceramic Technology
- Vol. 3 (2) , 166-176
Abstract
Polycrystalline neodymium‐doped yttrium aluminum garnet (YAG), Nd: Y 3 Al 5 O 12 , has been produced in a transparent form and is being considered as a substitute for single crystal YAG in laser applications. To determine whether such a substitution could impact mechanical reliability, it is critical to compare the baseline mechanical properties of the single crystal and polycrystalline materials. In this study, elastic constants, hardness, fracture toughness and strength properties were measured using standard experimental procedures. In addition, fractography was used to gain insight into the fracture process and the nature of the flaws controlling the strength behavior. Overall, it was determined that the mechanical behavior of the polycrystalline YAG was very similar to that of the single crystal material. The elastic constants of polycrystalline YAG were almost the same as the single crystal and the polycrystalline material showed slight advantages in hardness and fracture toughness. Surface machining flaws were found to control the strength behavior with the single crystal material being the more sensitive to contact damage and, hence exhibiting a lower strength.Keywords
This publication has 10 references indexed in Scilit:
- New data on the physical properties of Y3Al5O12-based nanocrystalline laser ceramicsCrystallography Reports, 2003
- Preparation of Transparent YAG Ceramic and Its Application to Window Material of Infrared Spectrophotometer.NIPPON KAGAKU KAISHI, 2000
- An Introduction to the Mechanical Properties of Ceramics1998
- Fabrication and Optical Properties of High‐Performance Polycrystalline Nd:YAG Ceramics for Solid‐State LasersJournal of the American Ceramic Society, 1995
- High-temperature elastic constants of yttrium aluminum garnetJournal of Applied Physics, 1993
- Effect of Indenter Geometry on Controlled-Surface-Flaw Fracture ToughnessJournal of the American Ceramic Society, 1983
- Controlled Flaws in Ceramics: A Comparison of Knoop and Vickers IndentationJournal of the American Ceramic Society, 1983
- A Critical Evaluation of Indentation Techniques for Measuring Fracture Toughness: II, Strength MethodJournal of the American Ceramic Society, 1981
- Fracture surface analysis of ceramicsJournal of Materials Science, 1976
- Temperature Dependence of the Elastic Constants of Yttrium Aluminum GarnetJournal of Applied Physics, 1967