Modeling of Fretting Wear Under Gross Slip and Partial Slip Conditions
Authors:
- 2 February 2007
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 129 (3) , 528-535
Abstract
The paper presents a numerical model to investigate fretting wear either under partial or gross slip conditions. An efficient three-dimensional elastic–static contact model to solve both the normal contact problem and the tangential contact problem is presented. The contact model is validated with analytical solutions for a sphere on flat geometry. A wear law issued from the literature and based on the friction energy is used to simulate surface wear. Numerical friction logs are obtained and the wear rate evolution is found to be highly dependent on the tangential displacement.Keywords
This publication has 24 references indexed in Scilit:
- Wear kinetics of Ti–6Al–4V under constant and variable fretting sliding conditionsWear, 2005
- A quantitative approach of Ti–6Al–4V fretting damage: friction, wear and crack nucleationWear, 2004
- The effect of slip regime on fretting wear-induced stress evolutionInternational Journal of Fatigue, 2004
- A Numerical Three-Dimensional Model for the Contact of Layered Elastic/Plastic Solids With Rough Surfaces by a Variational PrincipleJournal of Tribology, 2000
- Quantification of fretting damageWear, 1996
- Oxidational wear of TiN coatings on tool steel and nitrided tool steel in unlubricated frettingWear, 1995
- Analysis of sliding behaviour for fretting loadings: determination of transition criteriaWear, 1995
- Mixed fretting regimeWear, 1995
- The third-body approach: A mechanical view of wearWear, 1984
- Variational Principles of Contact ElastostaticsIMA Journal of Applied Mathematics, 1977