Consolidation of carbon fiber laminae during polymer‐matrix composite fabrication, studied by electrical resistance measurement
Authors:
- 1 February 2001
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 22 (1) , 42-46
Abstract
The consolidation of carbon fiber epoxy‐matrix laminae during composite fabrication by lamination (involving consolidation, curing and cooling) was found to hastened and to occur to a greater extent by increasing the pressure. The consequence of better consolidation remained after curing and subsequent cooling. A higher pressure resulted in a lower throughthickness resistivity in a composite after curing and cooling. The extent of consolidation was quantitatively described by N/No (the ratio of the number of fiber‐fiber contacts between adjacent laminae at a given time, divided by that at the start of consolidation), which was calculated from the measured through‐thickness electrical resistivity. From the variation of N/No during heating in the process of consolidation, three stages of consolidation were observed. In the first stage, N/No increased very gradually; in the second stage, N/No increased abruptly; in the third stage, N/No increased at a moderate rate.Keywords
This publication has 5 references indexed in Scilit:
- A low resolution pulsed NMR and ultrasound study to monitor the cure of an epoxy resin adhesiveInternational Journal of Adhesion and Adhesives, 1998
- In-situcure monitoring using optical fibre sensors - a comparative studySmart Materials and Structures, 1998
- Monitoring autoclave cure in commercial carbon fibre/epoxy compositesComposites Part B: Engineering, 1998
- Sensing delamination in a carbon fiber polymer‐matrix composite during fatigue by electrical resistance measurementPolymer Composites, 1997
- Dielectric parameters to monitor the crosslink of epoxy resinsJournal of Applied Polymer Science, 1997