Analysis of the Particle Formation Process of Structured Microparticles
- 24 February 2015
- journal article
- research article
- Published by American Chemical Society (ACS) in Molecular Pharmaceutics
- Vol. 12 (8) , 2562-2573
Abstract
The particle formation process for microparticles of cellulose acetate butyrate dried from an acetone solution was investigated experimentally and theoretically. A monodisperse droplet chain was used to produce solution microdroplets in a size range of 55–70 μm with solution concentrations of 0.37 and 10 mg/mL. As the droplets dried in a laminar air flow with a temperature of 30, 40, or 55 °C, the particle formation process was recorded by two independent optical methods. Dried particles in a size range of 10–30 μm were collected for morphology analysis, showing hollow, elongated particles whose structure was dependent on the drying gas temperature and initial solution concentration. The setup allowed comprehensive measurements of the particle formation process to be made, including the period after initial shell formation. The early particle formation process for this system was controlled by the diffusion of cellulose acetate butyrate in the liquid phase, whereas later stages of the process were dominated by shell buckling and folding.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
- Alberta Innovates - Technology Futures
This publication has 92 references indexed in Scilit:
- Influence of organic films on the evaporation and condensation of water in aerosolProceedings of the National Academy of Sciences, 2013
- Electrochemistry in an Acoustically Levitated DropAnalytical Chemistry, 2013
- Single droplet drying for optimal spray drying of enzymes and probioticsTrends in Food Science & Technology, 2012
- Inkjet printing as a novel medicine formulation techniqueJournal of Controlled Release, 2011
- Development of an Inhaled Dry-Powder Formulation of Tobramycin Using PulmoSphere™ TechnologyJournal of Aerosol Medicine and Pulmonary Drug Delivery, 2011
- Monodisperse fine aerosol generation using fluidized bedPowder Technology, 2010
- Numerical analysis of the interactions between evaporating droplets in a monodisperse streamInternational Journal of Heat and Mass Transfer, 2010
- Pharmaceutical Particle Engineering via Spray DryingPharmaceutical Research, 2007
- Thermoelectric Manipulation of Aqueous Droplets in Microfluidic DevicesAnalytical Chemistry, 2007
- Generation of monodisperse aerosol standardsEnvironmental Science & Technology, 1973