Statistical Modeling for Assessment of Dipper Stick Service Life
- 20 September 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 931, 417-421
Abstract
This paper presents an evaluation of the minimum dipper stick service life in the unsafe cross-section; it is based on statistical simulation known as Monte Carlo method. Source data on the bearing capacity parameters as well as on the values of stresses in the unsafe cross-section are presented as small samples. Statistical simulation is used to create a finite general population of data on machine parts my means of an intermediate subpopulation using order statistics distributions.Keywords
This publication has 6 references indexed in Scilit:
- Statistical modeling for risk assessment at sudden failures of construction equipmentMATEC Web of Conferences, 2017
- Determination of conditions for reliability of travel parameters estimation in a network using “floating” carsIOP Conference Series: Earth and Environmental Science, 2017
- Use of statistical simulation in construction planningMATEC Web of Conferences, 2017
- Investigation of Dependencies between Parameters of Two-component Models of the Kinetic Theory of Traffic Flow and Traffic CharacteristicsTransportation Research Procedia, 2017
- Determination of Rheological Parameters of Polyvinylchloride at Different TemperaturesMATEC Web of Conferences, 2016
- The Weibull Distribution2008