A Simple Route of Modifying Copper Electrodes for the Determination of Methanol and Ethylene Glycol
Authors:
- 22 June 2012
- journal article
- research article
- Published by Wiley in Electroanalysis
- Vol. 24 (7) , 1639-1645
Abstract
Copper foil electrodes were modified in a stirred NaOH solution at room temperature. Measurements with scanning electron microscopy, energy‐dispersive X‐ray spectroscopy and X‐ray photoelectron spectroscopy confirmed the simultaneous structural transformation and chemical modification of the foil surface. The as‐prepared electrodes produced isolated anodic peaks in the cyclic voltammogram of methanol or ethylene glycol in alkaline solution. The highest anodic peak current was achieved at the electrode that was modified for 5 hours. Amperometric study illustrates that the modified electrode can detect lower than 100 µM methanol with a sensitivity of 15.8 µA/mM or 10 µM ethylene glycol with a sensitivity of 193 µA/mM. Importantly, the method is robust and the prepared electrodes show great reproducibility.Keywords
This publication has 43 references indexed in Scilit:
- Electrochemical fabrication of complex copper oxide nanoarchitectures via copper anodization in aqueous and non-aqueous electrolytesMaterials Letters, 2011
- Biocatalytic anode for glucose oxidation utilizing carbon nanotubes for direct electron transfer with glucose oxidaseElectrochemistry Communications, 2009
- Vertically Aligned CuO Nanowires Based Electrode for Amperometric Detection of Hydrogen PeroxideElectroanalysis, 2008
- Flow-injection analysis of glucose without enzyme based on electrocatalytic oxidation of glucose at a nickel electrodeTalanta, 2007
- Electrooxidation of Aliphatic and Aromatic Amines at a Ni,Al Based Hydrotalcite Modified ElectrodeElectroanalysis, 2006
- Direct ethanol fuel cell (DEFC): Electrical performances and reaction products distribution under operating conditions with different platinum-based anodesJournal of Power Sources, 2006
- Electrocatalytic Oxidation of Ethylene Glycol in Alkaline SolutionJournal of the Electrochemical Society, 2005
- Low frictional copper oxide film prepared with sodium hydroxide solutionSurface and Interface Analysis, 2004
- Amperometric determination of ethanol in beverages at copper electrodes in alkaline mediumAnalytica Chimica Acta, 2002
- Electrochemical characteristics of conductive carbon cement as matrix for chemically modified electrodesAnalytica Chimica Acta, 1995