Comparing the Performance and Limitations of a Downsized Formula SAE Engine in Normally Aspirated, Supercharged and Turbocharged Modes
Authors:
- 13 November 2006
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
This paper compares the performance of a small two cylinder, 430 cm3 engine which has been tested in a variety of normally aspirated (NA) and forced induction modes on 98-RON pump gasoline. These modes are defined by variations in the induction system and associated compression ratio (CR) alterations needed to avoid knock and maximize volumetric efficiency (ηVOL). These modes included: (A)NA with carburetion (B)NA with port fuel injection (PFI) (C)Mildly Supercharged (SC) with PFI (D)Highly Turbocharged (TC) with PFI The results have significant relevance in defining the limitations for small downsized spark ignition (SI) engines, with power increases needed via intake boosting to compensate for the reduced swept volume. Performance is compared in the varying modes with comparisons of brake mean effective pressure (BMEP), brake power, ηVOL, brake specific fuel consumption (BSFC) and brake thermal efficiency (ηTH). The test engine used in experiments was specifically designed and configured for Formula SAE, SAE's student Formula race-car competition. A downsized twin cylinder in-line arrangement was chosen, which featured double overhead camshafts and four valves per cylinder. Most of the engine components were specially cast or machined from billets. Experimental results showed BSFC or ηTH values in the order of 240 g/kWh or 34% could be achieved. TC BMEP values in the region of 25 bar were also achieved, the highest recorded for small engines on pump gasoline [1]. The engine was installed into successive Melbourne University Racing (MUR) vehicles in 2003 and 2004, where it was very competitive, finishing first in the fuel economy event at the 2004 Australasian competition.Keywords
This publication has 16 references indexed in Scilit:
- Highly Turbocharging a Flow Restricted Two Cylinder Small Engine - Turbocharger DevelopmentSAE International Journal of Advances and Current Practices in Mobility, 2007
- Highly Turbocharging a Restricted, Odd Fire, Two Cylinder Small Engine - Design, Lubrication, Tuning and ControlSAE International Journal of Advances and Current Practices in Mobility, 2006
- Design and Development of a Gasketless Cylinder Head / Block Interface for an Open Deck, Multi Cylinder, Highly Turbocharged Small EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- Exhaust Gas Recirculation for Improved Part and Full Load Fuel Economy in a Turbocharged Gasoline EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- Development of a 430cc Constant Power Engine for FSAE CompetitionSAE International Journal of Advances and Current Practices in Mobility, 2006
- Future Potential and Development Methods for High Output Turbocharged Direct Injected Gasoline EnginesSAE International Journal of Advances and Current Practices in Mobility, 2006
- Turbocharging Concepts for Downsized DI Gasoline EnginesSAE International Journal of Advances and Current Practices in Mobility, 2004
- Advanced Gasoline Engine Turbocharging Technology for Fuel Economy ImprovementsSAE International Journal of Advances and Current Practices in Mobility, 2004
- Downsizing a Gasoline Engine Using Turbocharging with Direct InjectionSAE International Journal of Advances and Current Practices in Mobility, 2003
- Turbocharging for Fuel EfficiencySAE International Journal of Advances and Current Practices in Mobility, 1983