Anatomy of the supraclavicular fossa portal in shoulder arthroscopy
Authors:
- 1 December 1990
- journal article
- Published by Wiley in Arthroscopy
- Vol. 6 (4) , 297-300
Abstract
Because of the need for a third portal for operative procedures during glenohumeral joint arthroscopy, we studied the anatomy of the supraclavicular fossa portal with the humerus in various degrees of abduction and the trochar placed at various angles. Our purpose was to establish a “safe zone” of introduction that would avoid damage to the tendinous portion of the rotator cuff. Eight shoulder specimens were studied. Sharp‐ and blunt‐tipped 4‐mm trocars were used to enter the joint. The trapezius was penetrated at all angles of humeral abduction and trocar angulation. The trocar penetrated the tendinous portion of the rotator cuff in all specimens at 90° of abduction, seven of eight specimens at 70°, six of eight specimens at 60°, and three of eight specimens at 45° of abduction. No penetration of the musculotendinous portion occurred when the arm was in 30° of abduction or at the side. When it is necessary to use the supraclavicular portal, traction should be released and the humerus should be brought down to at least 45°. The trocar should be introduced laterally at 30° and angled slightly posteriorly to avoid the tendinous portion of the rotator cuff.Keywords
This publication has 7 references indexed in Scilit:
- Rotator cuff tearsThe American Journal of Sports Medicine, 1989
- Anterior portals in shoulder arthroscopyArthroscopy, 1989
- Shoulder arthroscopy with the patient in the beach‐chair positionArthroscopy, 1988
- Arthroscopy of the ShoulderOrthopedic Clinics of North America, 1987
- Shoulder arthroscopy: A modified approachArthroscopy, 1985
- Shoulder Joint ArthroscopyOrthopedics, 1983
- Arthroscopy of the ShoulderOrthopedic Clinics of North America, 1980