Improvement of the Mechanical Properties of High Manganese Steels by Combination of Precipitation Hardening and Mechanical Twinning
- 15 February 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 15-17, 852-857
Abstract
Twinning-Induced Plasticity steels (TWIP steels) are extensively studied due to their ultra-high strain-hardening rate, that brings about a remarkable combination of ductility and strength. Twinning can be observed in high manganese-carbon steels. This paper considers hardening by combination of mechanical twinning with carbide precipitation. The kinetics of precipitation and the morphological evolution of carbides with annealing time were studied for two different TWIP steels with high manganese and carbon contents. The steels are first cold-rolled and then annealed at 800°C for recrystallization and carbide precipitation. Depending on the steel composition, the kinetics of precipitation and the morphology of the carbides are quite different. The influence of the annealing cycle on the mechanical properties has also been assessed. The results are used to discuss the influence of composition, stacking fault energy (SFE) and carbide precipitation on twinning. We show that the usual criteria based on the SFE only are not sufficient to characterize the twinning ability of a steel.Keywords
This publication has 5 references indexed in Scilit:
- A physical model of the twinning-induced plasticity effect in a high manganese austenitic steelMaterials Science and Engineering: A, 2004
- Modeling of mechanical twinning in a high manganese content austenitic steelMaterials Science and Engineering: A, 2004
- Mechanical twins, their development and growthEuropean Journal of Mechanics - A/Solids, 2003
- Non-metallic inclusion and intragranular nucleation of ferrite in Ti-killed C–Mn steelActa Materialia, 2003
- Effect of aluminium on deformation mode and mechanical properties of austenitic FeMnCrAlC alloysMaterials Science and Engineering: A, 1995