Orientation Controls Tribological Performance of 3D-Printed PLA and ABS
Authors:
Open Access
- 31 October 2023
- journal article
- conference paper
- Published by Japanese Society of Tribologists in Tribology Online
- Vol. 18 (6) , 302-312
Abstract
Additive manufacturing is rapidly growing in popularity for manufacturing parts with tunable mechanical properties. Recent studies show that mechanical properties can be achieved by controlling the layer orientation and build structure. In this work the effect of print orientation on tribological properties of 3D printed PLA and ABS are investigated. PLA and ABS samples are printed using fused deposition modeling (FDM) with three different print orientations. Tribological results show that variation in build direction relative to the sliding direction causes anisotropy in wear properties. The best wear properties are achieved with the samples printed where the layers remain orthogonal to the sliding direction. The coefficient of friction remains mostly unaffected by print orientation. PLA samples demonstrate significantly better tribological properties compared to ABS. Varying the sliding speed between the interacting surfaces also affects the wear properties of both PLA and ABS. The results suggest that optimizing the build orientation can improve the wear performance of additively manufactured thermoplastics. This enables an additional paradigm when designing for functionally graded materials.Keywords
All Related Versions
This publication has 55 references indexed in Scilit:
- High-cycle bending fatigue properties of additive-manufactured ABS and PLA polymers fabricated by fused deposition modeling 3D-printingForces in Mechanics, 2021
- Effect of print orientation and bronze existence on tribological and mechanical properties of 3D-printed bronze/PLA compositeThe International Journal of Advanced Manufacturing Technology, 2020
- Multiscale mechanical and tribological characterizations of additively manufactured polyamide 12 parts with different print orientationsJournal of Manufacturing Processes, 2019
- Investigation on the tribological behavior and wear mechanism of parts processed by fused deposition additive manufacturing processJournal of Manufacturing Processes, 2017
- Influence of processing and orientation print effects on the mechanical and thermal behavior of 3D-Printed ULTEM® 9085 MaterialAdditive Manufacturing, 2017
- Effect of processing parameters and graphite content on the tribological behaviour of 3D printed acrylonitrile butadiene styreneMaterialwissenschaft und Werkstofftechnik, 2015
- Gemini Interfaces in Aqueous Lubrication with HydrogelsTribology Letters, 2014
- An investigation on sliding wear of FDM built partsCIRP Journal of Manufacturing Science and Technology, 2012
- Measurement Uncertainties in Wear RatesTribology Letters, 2009
- Addressing Practical Challenges of Low Friction Coefficient MeasurementsTribology Letters, 2009