An experimental study of the influence from fibre architecture on the permeability of 3D-woven textiles
- 1 August 2015
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 34 (17) , 1444-1453
Abstract
In this work experimental measurements of the permeability of fully interlaced 3D-woven carbon fibre preforms are performed using the unsaturated parallel flow method. The effect on the permeability from three different parameters is studied by altering the architecture of woven preforms and varying mould sizes in a duct flow set-up. Influences from the geometrically different surface layers of the woven preforms, from fibre volume fraction and from warp yarn crimp are studied. The measurements show negligible influence on the permeability from crimp and the fraction of weave surface layers while the fibre volume fraction has a prominent influence. However, the effect is not consistent in terms of fibre volume fraction variation alone but depends on how it is varied.Keywords
This publication has 28 references indexed in Scilit:
- Geometrical modelling of 3D woven reinforcements for polymer composites: Prediction of fabric permeability and composite mechanical propertiesComposites Part A: Applied Science and Manufacturing, 2014
- Analysis of Compressibility and Permeability of Selected 3D Woven ReinforcementsJournal of Composite Materials, 2010
- Modeling the Unsaturated Flow in Liquid Composite Molding Processes: A Review and Some ThoughtsJournal of Composite Materials, 2004
- In-plane permeability measurements: a nordic round-robin studyComposites Part A: Applied Science and Manufacturing, 2000
- Experimental analysis and simulation of flow through multi‐layer fiber reinforcements in liquid composite moldingPolymer Composites, 1998
- An investigation into the effects of fabric architecture on the processing and properties of fibre reinforced composites produced by resin transfer mouldingComposites Part A: Applied Science and Manufacturing, 1998
- The Effects of Fluid Type and Viscosity on the Steady-State and Advancing Front Permeability Behavior of Textile PreformsJournal of Reinforced Plastics and Composites, 1997
- Measurement of in‐plane permeability of anisotropic fiber reinforcementsPolymer Composites, 1996
- Measurement techniques and effects on in-plane permeability of woven cloths in resin transfer mouldingComposites Part A: Applied Science and Manufacturing, 1996
- Permeability characterization. Part 1: A proposed standard reference fabric for permeabilityPolymer Composites, 1995