Importance of Spray-Bowl Interaction in a DI Diesel Engine Operating under PCCI Combustion Mode
Authors:
- 20 April 2009
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In the Premixed-Charge Compression Ignition (PCCI) combustion mode, fuel is injected fairly early before top-dead-center (TDC) of compression compared to the conventional near-TDC injection combustion mode. Early fuel injection into a low temperature in-cylinder environment results in long ignition delay and high peak heat release rate. Since the onset of ignition occurs after the end of injection, importance of spray and bowl induced flow field and mixing is not so obvious. In the present work, computational analysis is used to investigate the effects of spray-bowl interactions on PCCI combustion and emissions at a light-load (4Bar BMEP) operation of a medium-duty, direct injection diesel engine. Multidimensional CFD code KIVA-3V coupled with detailed chemical kinetics is used to perform combustion simulations. The model is first validated with the available engine measurements and then applied to correlate in-cylinder details of flow-field, temperature, and soot with measured trends in exhaust soot emissions. The simulations are performed for two different piston bowl shapes, a range of injector spray cone angles (100º-158º), and a range of start of injection (SOI) timings (15º BTDC to 35º BTDC). The model predictions suggest that the optimum combination of spray cone angle and SOI to produce lower exhaust emissions of soot is dependent on the level of reentrancy and radius of curvature of the piston bowl near the bowl-lip. Interaction of spray plume, piston bowl, and squish flows generate a complex flow field structure near the piston bowl wall. This flow structure plays an important role in post heat-release mixing and soot oxidation.Keywords
This publication has 23 references indexed in Scilit:
- Studying the Influence of Direct Injection on PCCI Combustion and Emissions at Engine Idle Condition Using Two Dimensional CFD and Stochastic Reactor ModelSAE International Journal of Advances and Current Practices in Mobility, 2008
- The Effects of Injection Conditions and Combustion Chamber Geometry on Performance and Emissions of DI-PCCI Operation in a Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2007
- Spray Angle and Rail Pressure Study for Low NOx Diesel CombustionSAE International Journal of Advances and Current Practices in Mobility, 2007
- A Computational Investigation into the Effects of Spray Targeting, Bowl Geometry and Swirl Ratio for Low-Temperature Combustion in a Heavy-Duty Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2007
- Premixed Compression Ignition (PCI) Combustion with Modeling-Generated Piston Bowl Geometry in a Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- Spray Targeting to Minimize Soot and CO Formation in Premixed Charge Compression Ignition (PCCI) Combustion with a HSDI Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- PCCI Operation with Early Injection of Conventional Diesel FuelSAE International Journal of Advances and Current Practices in Mobility, 2005
- Investigation of Premixed Lean Diesel Combustion with Ultra High Pressure InjectionSAE International Journal of Advances and Current Practices in Mobility, 2005
- Experimental Investigation of PCCI-DI Combustion on Emissions in a Light-Duty Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2004
- Emission Characteristics of Premixed Lean Diesel Combustion with Extremely Early Staged Fuel InjectionSAE International Journal of Advances and Current Practices in Mobility, 1996