Laser induced backside wet and dry etching of solar glass by short pulse ytterbium fiber laser irradiation
Authors:
- 5 April 2012
- journal article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 24 (2) , 022005
Abstract
Microstructures fabricated on the surface of solar glass have the potential to improve the performance of solar cells. In this paper, in order to overcome the high transmittance to 1064 nm center wavelength fiber laser irradiation and realize high efficiency process on transparent glass substrates, different absorber materials, including alumina powder, alumina ceramic wafers, and copper sulphate solutions, were applied for dry and wet etching under the irradiation of 1064 nm pulsed fiber laser respectively. The laser fluence was varied from 7 to 10 J/cm2 with a pulse repetition rate of 20 kHz. The morphology of trenches etched by means of laser induced backside dry etching (LIBDE) and by laser induced backside wet etching was measured using a scanning electronic scope, and compared from the aspects of etch depth and width, as well as the roughness. On the basis of this comparison, a higher etch rate can easily be obtained by dry etching, while lower roughness is a feature of wet etching. The mechanism of LIBDE of solar glass was investigated by demonstrating the procedure of dry etching using alumina ceramic wafer. Moreover, the etch threshold fluence was estimated to be 7.47 J/cm2 by extrapolation. Both types of laser induced backside etching techniques, wet and dry, show the evidence of effective microprocessing on solar glass.Keywords
This publication has 22 references indexed in Scilit:
- Microstructuring of fused silica by laser-induced backside wet etching using picosecond laser pulsesApplied Surface Science, 2010
- Laser-induced backside wet etching of fluoride and sapphire using picosecond laser pulsesApplied Physics A, 2010
- Laser-induced backside dry etching: wavelength dependenceJournal of Physics D: Applied Physics, 2008
- Laser etching of glass substrates by 1064 nm laser irradiationApplied Physics A, 2008
- A deep micro-trench on silica glass fabricated by laserinduced backside wet etching (LIBWE)Journal of Physics: Conference Series, 2007
- Backside etching of fused silica with ultra-short laser pulses at the interface to absorbing liquidJournal of Physics: Conference Series, 2007
- Direct laser etching of transparent materials: high quality surface patterning and figuring for micro-optical applications2006
- Laser etching of periodic 1D and 2D submicron relief gratings on prestructured fused silica surface2006
- Excimer laser ablation of glass-based arrayed microstructures for biomedical, mechanical, and optical applicationsJournal of Laser Applications, 2005
- Laser etching of fused silica using an adsorbed toluene layerApplied Physics A, 2004