Self-assembled monolayers on ta-C surfaces: Effect of sp3/sp2 ratio on adsorption rate and friction
Authors:
- 9 May 2003
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (10) , 8722-8724
Abstract
Self-assembled monolayers of 1H,1H,2H,2H-perfluorodecyltrichlorosilane (FDTS), were deposited on tetrahedral amorphous carbon (ta-C) surfaces by immersion process. The ta-C films were deposited on silicon substrates by using a filtered cathodic arc system and the ratios of the ta-C films were controlled by changing the sample bias voltage. In results of the x-ray photoelectron spectroscopy measurements, it was found that the adsorption rate of silane molecules on sample A (whose content is about 85%) was higher than that of on sample B (whose content is about 65%). This trend was qualitatively the same as that found for water contact angle measurement. The friction forces of FDTS/sample A and FDTS/sample B measured by lateral force microscope show FDTS/sample A has lower friction value than that of FDTS/sample B. We conclude the following: the density of dangling bonds, which are effective adsorption sites for silane molecules, increases with content. Consequently, the adsorption rate of silane molecules increases with increasing content. The friction force decreases with increasing content of the ta-C film since more of a close-packed self-assembled monolayer can be formed.
Keywords
This publication has 5 references indexed in Scilit:
- Self-assembled monolayer formation on magnetic hard disk surface and friction measurementsJournal of Applied Physics, 2002
- TETRAHEDRAL AMORPHOUS CARBON (Ta-C) ULTRA THIN FILMS FOR SLIDER OVERCOAT APPLICATIONInternational Journal of Modern Physics B, 2002
- Comparison of deposition methods for ultra thin DLC overcoat film for MR headDiamond and Related Materials, 2001
- The characterization of nitrogen content, diamond-like carbon field emission arrays using a magnetic filtered arc methodThin Solid Films, 2000
- Direct evaluation of the sp3 content in diamond-like-carbon films by XPSApplied Surface Science, 1998