Interface properties and thermodynamic analysis of laser–arc hybrid welded Al/steel joint
Authors:
- 1 May 2013
- journal article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 18 (4) , 293-300
Abstract
Fibre laser–cold metal transfer hybrid welding was introduced to join AA 6061 aluminium alloy with AISI 304 stainless steel using Al–12Si filler wire. Interface properties and microstructure of welded joints were observed by optical microscope, scanning electron microscope, energy dispersive spectrometry and X-ray diffraction techniques. A serrated intermetallic compound (IMC) layer was found at the interface between fusion zone and stainless steel. The morphology of IMC layer was uniform from the top to the bottom, and its average thickness was 3 μm. The IMC layer consisted of two layers: Al8(Fe,Cr)2Si layer close to fusion zone and (Al,Si)13Fe4 layer close to stainless steel. The joint fractured at the IMC layer and presented a tensile strength of 165 MPa. The formation of the IMC layer was closely related with the thermodynamic and kinetic behaviours of the interface and fast cooling rate of hybrid welding.Keywords
This publication has 18 references indexed in Scilit:
- High strength lap joint of aluminium and stainless steels fabricated by friction stir welding with cutting pinScience and Technology of Welding and Joining, 2012
- Characterisation of the cold metal transfer (CMT) process and its application for low dilution claddingJournal of Materials Processing Technology, 2011
- Effects of resistance spot welding parameters on microstructures and mechanical properties of dissimilar material joints of galvanised high strength steel and aluminium alloyScience and Technology of Welding and Joining, 2011
- Welding process impact on residual stress and distortionScience and Technology of Welding and Joining, 2009
- Spreading behavior and microstructure characteristics of dissimilar metals TIG welding–brazing of aluminum alloy to stainless steelMaterials Science and Engineering: A, 2009
- The CMT short-circuiting metal transfer process and its use in thin aluminium sheets weldingMaterials & Design (1980-2015), 2009
- Steel to aluminium braze welding by laser process with Al–12Si filler wireScience and Technology of Welding and Joining, 2008
- Evaluation of cold metal transfer (CMT) process for welding aluminium alloyScience and Technology of Welding and Joining, 2006
- Control of intermetallic compound layers at interface between steel and aluminum by diffusion-treatmentMaterials Science and Engineering: A, 2002
- Intermetallic compound layer growth between solid iron and molten aluminiumMaterials Science and Engineering: A, 1998