Feed-Forward Technique to Measure the Reflection Coefficient Under CW High-Power Signals
Open Access
- 23 July 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 66 (10) , 4627-4633
Abstract
This paper describes a measurement setup to obtain the reflection coefficient response over the frequency of a given device when this is subjected to a single-tone high-power (HP) signal. The proposed system is based on a feed-forward technique to cancel the reflected HP signal before reaching the vector network analyzer. This allows measuring the effects of the HP interfering signal into the device's low-power frequency response. This technique does not require either power-calibrated standards or complex calibration techniques. Experiments in several devices are also reported to validate the suitability of this technique.Keywords
Funding Information
- Ministerio de Ciencia, Tecnología e Innovación (TEC2017-84817-C2-2-R, TEC2017-88343-C4-2-R, EUIN2017-88928)
This publication has 7 references indexed in Scilit:
- Absorptive Limiter for Frequency-Selective CircuitsIEEE Microwave and Wireless Components Letters, 2014
- Multi-tone and multi-port cases2013
- Automatic leaking carrier canceller adjustment techniquesEURASIP Journal on Embedded Systems, 2013
- Robust Analog Canceller for High-Dynamic-Range Radio Frequency MeasurementIEEE Transactions on Microwave Theory and Techniques, 2012
- A survey of techniques for improving the calibration of high-power network analyzers2011
- Automated Broadband High-Dynamic-Range Nonlinear Distortion Measurement SystemIEEE Transactions on Microwave Theory and Techniques, 2010
- Frequency Tuning and Spurious Signal Generation at Microwave Frequencies in Ferroelectric ${\hbox{SrTiO}}_{3}$ Thin-Film Transmission LinesIEEE Transactions on Microwave Theory and Techniques, 2007