Dimension reduction and 2D-visualization for early change of state detection in a machining process with a variational autoencoder approach
Authors:
- 14 November 2020
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 111 (11-12) , 3597-3611
Abstract
No abstract availableKeywords
Funding Information
- Fonds de Recherche du Québec - Nature et Technologies (257668)
This publication has 36 references indexed in Scilit:
- A review on the application of deep learning in system health managementMechanical Systems and Signal Processing, 2018
- Effect of temperature and porosity on the vibration behavior of two-dimensional functionally graded micro-scale Timoshenko beamJournal of Vibration and Control, 2017
- Fracture Analysis of a Special Cracked Lap Shear (CLS) Specimen with Utilization of Virtual Crack Closure Technique (VCCT) by Finite Element MethodsJournal of Failure Analysis and Prevention, 2017
- "Why Should I Trust You?"2016
- Prognostics: a literature reviewComplex & Intelligent Systems, 2016
- A review of diagnostic and prognostic capabilities and best practices for manufacturingJournal of Intelligent Manufacturing, 2016
- Cloud-enabled prognosis for manufacturingCIRP Annals, 2015
- A review of machining monitoring systems based on artificial intelligence process modelsThe International Journal of Advanced Manufacturing Technology, 2009
- Cyclostationarity by examplesMechanical Systems and Signal Processing, 2009
- An investigation of tool-wear monitoring in a high-speed machining processSensors and Actuators A: Physical, 2004