Fabrication and Properties of Al/Al-Cu Functionally Graded Material
Authors:
- 1 February 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 675-677, 575-578
Abstract
Five-layered Al/Al-Cu functionally graded material (FGM) was fabricated by powder metallurgy technology. The microstructure and composition of the prepared specimen were studied. Vickers hardness, flexural strength and fracture surface morphology were also measured. The results showed that Al/Al-Cu graded material with dense structure and compositional continuous change was obtained by solution-precipitation method. The graded materials presented a compositional continuous change along the graded direction because of the diffusion effect, and the Vickers hardness was liner proportional to the distribution of Cu content. Compared with pure sintered Al, remarkable improvement on hardness and fracture strength was achieved due to the CuAl2 phase dispersively distributed in the matrix. With the increase of Cu content, the fracture mode changed from tough fracture to the tendency of brittle fracture.Keywords
This publication has 7 references indexed in Scilit:
- Fabrication of alumina/zirconia functionally graded material: From optimization of processing parameters to phenomenological constitutive modelsMaterials Science and Engineering: A, 2008
- Functionally graded Al–Al3Ni in situ intermetallic composites: Fabrication and microstructural characterizationJournal of Alloys and Compounds, 2008
- Effect of stress ratio on fatigue crack propagation in a functionally graded metal matrix compositeComposites Science and Technology, 2004
- Processing and characterization of metal–ceramics functionally gradient materialsJournal of Materials Processing Technology, 2001
- Mechanical properties of polycrystalline Ti3SiC2 at ambient and elevated temperaturesActa Materialia, 2001
- Structure and properties of functionally gradient aluminium alloy 2124/SiC compositesMaterials Science and Technology, 1994
- Thermal behaviour and magnetic properties of Fe/Al2O3multilayersJournal of Physics: Condensed Matter, 1994