Optimization of cell geometry for a conventional sputter ion pump by a particle-in-cell simulation
Authors:
Open Access
- 1 April 2009
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 27 (3) , 485-491
Abstract
The authors performed simulations of Penning discharge at the low magnetic field using a particle-in-cell computer code to derive the optimum cell geometry of a sputter ion pump (SIP). The energy and angle distributions of incident ions on the cathode of a Penning cell were directly obtained from the simulation. Based on these data, the authors calculated the amount of deposited Ti on the inner surface of the cell, which was found to be proportional to intrinsic pumping speed of a SIP, and then estimated the effective pumping speed for various cell geometries. In this calculation, the incident ions on the outer region of the cathode as well as those at the center were analyzed, and the effect of the ionizationless region on Penning discharge was also taken into account. The calculated values agreed well with the existing experimental data, especially in the region of a small cell radius. The results also show that the cell radius should be at least 5 mm for effective pumping, and the optimum geometrical parameters for a conventional sputter ion pump have the radius of 8.5 mm and the gap of 7 mm at the applied voltage of 5600 V.Keywords
This publication has 21 references indexed in Scilit:
- Velocity distributions in magnetron sputterIEEE Transactions on Plasma Science, 1998
- An object-oriented electromagnetic PIC codeComputer Physics Communications, 1995
- Studies of New Zealand Hepaticae. 7. The Status of SteereomitriumThe Bryologist, 1994
- Design studies of distributed ion pumpsJournal of Vacuum Science & Technology A, 1987
- Calculation of sputtering ion pump speedJournal of Vacuum Science and Technology, 1982
- A new approach for computing diode sputter-ion pump characteristicsJournal of Vacuum Science and Technology, 1974
- On the theory of electrical characteristics of a penning discharge at low magnetic fieldPhysica, 1969
- Investigation of a low pressure penning dischargePhysica, 1967
- Mechanism of the Penning Discharge at Low PressuresJournal of Applied Physics, 1962
- Electronic Ultra-High Vacuum PumpReview of Scientific Instruments, 1958