Multimodal Hydrostatic Actuators for Wearable Robots: A Preliminary Assessment of Mass-Saving and Energy-Efficiency Opportunities
- 23 May 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 8112-8118
Abstract
Wearable robots are limited by their actuators performances because they must bear the weight of their own power system and energy source. This paper explores the idea of leveraging hybrid modes to meet multiple operating points with a lightweight and efficient system by using hydraulic valves to dynamically reconfigure the connections of a hydrostatic actuator. The analyzed opportunities consist in 1) switching between a highly geared power source or a fast power source, 2) dynamically connecting an energy accumulator and 3) using a locking mechanism for holding. Based on a knee exoskeleton case study analysis, results show that switching between gearing ratio can lead to a lighter and more efficient actuator. Also, results show that using an accumulator to provide a preload continuous force has great mass-saving potential, but does not reduce mass significantly if used as a power booster for short transients. Finally, using a locking valve can slightly reduce battery mass if the work cycle includes frequent stops. The operating principles of the proposed multimodal schemes are demonstrated with a one-DOF prototype.Keywords
All Related Versions
This publication has 22 references indexed in Scilit:
- Design and Analysis of the Active Dual-Mode Twisting Actuation MechanismIEEE/ASME Transactions on Mechatronics, 2017
- Optimization and Design Principles of a Minimal-Weight, Wearable Hydraulic Power Supply2017
- Jam-free gear–clutch mechanism for load-sensitive step transmission in robotic jointROBOMECH Journal, 2017
- A biologically-inspired multi-joint soft exosuit that can reduce the energy cost of loaded walkingJournal of NeuroEngineering and Rehabilitation, 2016
- A hybrid hydrostatic transmission and human-safe haptic telepresence robot2016
- An asymmetric compliant antagonistic joint design for high performance mobility2013
- Actuator design for high force proprioceptive control in fast legged locomotion2012
- Comparison of regenerative braking technologies for heavy goods vehicles in urban environmentsProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2012
- Estimation models for the preliminary design of electromechanical actuatorsProceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2011
- Energy efficient use of robotics in the automobile industry2011