Experimental and semi-analytical investigation of heat transfer in nucleate pool boiling by considering surface structuring methods
Authors:
- 6 April 2020
- journal article
- research article
- Published by Taylor & Francis in Experimental Heat Transfer
- Vol. 34 (4) , 293-313
Abstract
Pool boiling is the process in which the heating surface is submerged in a large body of stagnant liquid. In the present work, heat transfer in nucleate pool boiling is modeled both experimentally and semi-analytically with the consideration of surface structuring methods including wire electrical discharge machining (WEDM) and etching. The developed models consider variations of nucleation site density (NSD), contact angle and Prandtl number taking into account both pure and impure fluids. According to the results, by increasing wall superheat and contact angle, heat flux enhances. Also, rising Prandtl number results in heat flux enhancement. Comparing Sample 2 (structured by etching method), Sample 3 (structured by WEDM method), and Sample 4 (the surface with best performance) with Sample 1 (plain surface) indicates that the HTC is approximately 37%, 121%, and 177% higher than the plain surface, respectively. Comparison of the obtained results based on the semi-analytical model with existing experimental data and previous analytical models shows a good agreement.Keywords
This publication has 36 references indexed in Scilit:
- A nucleate boiling limitation model for the prediction of pool boiling CHFInternational Journal of Heat and Mass Transfer, 2007
- Active nucleation site density in boiling systemsInternational Journal of Heat and Mass Transfer, 2003
- Nucleate pool boiling heat transfer of pure liquids at low to moderate heat fluxesInternational Journal of Heat and Mass Transfer, 1996
- Effect of Surface Wettability on Active Nucleation Site Density During Pool Boiling of Water on a Vertical SurfaceJournal of Heat Transfer, 1993
- Subcooled flow boiling at high heat fluxInternational Journal of Heat and Mass Transfer, 1985
- Interfacial area and nucleation site density in boiling systemsInternational Journal of Heat and Mass Transfer, 1983
- Bubble growth rates in pure and binary systems: Combined effect of relaxation and evaporation microlayersInternational Journal of Heat and Mass Transfer, 1975
- The initial vapor bubble growth on a heated wall during nucleate boilingInternational Journal of Heat and Mass Transfer, 1969
- A New Correlation of Pool-Boiling Data Including the Effect of Heating Surface CharacteristicsJournal of Heat Transfer, 1969
- The mechanism of heat transfer in nucleate pool boiling—Part IInternational Journal of Heat and Mass Transfer, 1965